Frigidaire FGHB2844LM ユーザーズマニュアル

32

Visit our web site at

1-800-944-9044 (United States)

1-800-265-8352 (Canada)

•  Ice maker is turned off.

•  Refrigerator is not connected to water 

line or water valve is not open.

•  The water supply line is kinked.

•  The water filter is not seated

properly.

•  The water filter may be clogged

with foreign material.

•  Freezer ice maker wire signal arm is 

being held up by an item not allowing 

it to go in the on or down position.

•  Turn on ice maker.  For the fresh food ice maker, press and hold the 

“Ice Off” button for three (3) seconds until the indicator light is off.  

For the freezer ice maker, lower the wire signal arm. 

•  Connect the unit to the household water supply and ensure the 

water valve is open.

•  Ensure that the supply line does not kink when the refrigerator is 

pushed into place against the wall.

•  Remove and re-install the water filter. Be sure to push the filter

firmly so that you hear it lock solidly into position.

•  If water dispenses slowly or not at all, or if the filter is six (6)

months old or older, it should be replaced.

•  Move any item or frozen ice cubes that may block the signal arm 

from being in the on or down position.  See Automatic Ice 

Maker-Freezer section in manual.

•  Ice maker is producing less ice than 

you expect.

•  The water filter may be clogged with

foreign material.

•  The water supply line is kinked.

•  Saddle valve on cold water pipe is 

clogged or restricted by foreign material.

•  Heavy traffic, opening or closing of

the doors excessively.

•  The fresh food and freezer ice makers will each produce approximately 

2.5 pounds of ice every 24 hours depending on usage conditions.

•  If water dispenses slower than normal, or if the filter is six (6)

months old or older, it should be replaced.

•  Ensure that the supply line does not kink when the refrigerator is 

pushed into place against the wall.

•  Turn off household water line valve.  Remove valve.  Ensure that valve is 

not a self-piercing saddle valve. Clean valve. Replace valve if necessary.

•  Press Fast Freeze to temporarily increase ice production rate.

•  Ice maker wire signal arm is being held 

down by some package in the freezer 

that has fallen against the ice maker.

•  Move any item or frozen ice cubes that may block the signal arm 

from being in the off or upward position.  See Automatic Ice 

Maker-Freezer section in manual.

•  Ice cubes are not being used 

frequently enough or interruption of 

power for prolonged time.

•  Ice cubes are hollow (shells of ice with 

water inside). The hollow cubes break 

open in the bin and leak their water 

onto existing ice, which causes it to 

freeze together.

•  Remove ice container and discard ice.  The ice maker will pro-

duce fresh supply.  Ice should be used at least twice weekly to 

keep the cubes separated.

•  This generally occurs when the ice maker does not get enough 

water. This is usually the result of a clogged water filter or re-

stricted water supply. Replace the water filter and if the condition

still occurs check for a Saddle Valve, water valve not turned on 

all the way or kinked water supply line.

•  Dispenser lock out is engaged.

•  There is no ice in the bin to be dispensed.

•  The refrigerator doors are not com-

pletely closed.

•  Dispenser paddle has been pressed 

too long and the dispenser motor 

has overheated.

•  Press and hold control lock for three (3) seconds.

•  See the “Ice maker is not making any ice” section above.

•  Be sure the refrigerator doors are completely closed.

•  The motor overload protector will reset in about three (3) min-

utes and then ice can be dispensed.

•  Ice has melted and frozen around auger 

due to infrequent use, temperature 

fluctuations, and/or power outages.

•  Ice cubes are jammed between ice 

maker and back of ice container.

•  Remove ice container, thaw, and empty the contents.  Clean 

container, wipe dry, and replace in proper position.  When new 

ice is made, dispenser should operate.

•  Remove ice cubes that are jamming the dispenser.

•  Dispenser lock out is engaged.

•  Water filter not seated properly.

•  Water filter is clogged.

•  Household water line valve is not 

open.

•  Press and hold control lock for three (3) seconds. 

•  Remove and reinstall the water filter. Be sure to push the filter

firmly so that you hear it lock solidly into position.

•  Replace filter cartridge. Be sure to remove protective caps and push

the filter firmly so that you hear it lock solidly into position.

•  Open household water line valve.  See CONCERN column AU-

•  Water has not been dispensed for 

an extended period of time.

•  Unit not properly connected to cold 

water line.

•  Draw and discard 10-12 glasses of water to freshen the supply.

•  Connect unit to cold water line that supplies water to the kitchen 

faucet.