Frigidaire FGHB2869LE ユーザーズマニュアル

17

Your ice maker is turned on at the factory so it can work 

as soon as you install your refrigerator. If you cannot 

connect a water supply, set the ice maker’s On/Off icon 

to Off and turn off the water supply valve; otherwise, 

the ice maker’s fill valve may make a loud chattering

noise when it attempts to operate without water.

On occasion, unusually small ice cubes may be noticed 

in the bucket or in dispensed ice.  This could occur in 

normal operation of the ice maker.  If you start seeing 

these more frequently, it may be an indication of low 

water pressure or the water filter needs to be replaced.

As the water filter nears the end of its useful life and

becomes clogged with particles, less water is delivered 

to the ice maker during each cycle.  Remember, if it’s 

been six (6) months or longer since you last changed 

your water filter, replace the water filter with a new one.

Poor quality household water may require the filter to be

changed more frequently.

Turning off the ice maker will result in existing ice 

melting in the bin.

Turning off the ice maker will disable the ice dispenser.  

You will still be able to dispense water.



The water dispenser has a built-in device that shuts off 

the water flow after three (3) minutes of continuous

use. To reset this shutoff device, simply release the 

dispenser paddle. 



The ice maker also has a built-in plastic signal bale arm 

that automatically stops ice production when the ice bin 

is full. This signal arm should not be used to manually 

stop the ice maker.

For proper dispenser operation, recommended water 

supply pressure should fall between 30 psi and 100 

psi. Excessive pressure may cause water filter to

malfunction.

  1  Begin filling the tank by pressing and holding a

drinking glass against the water dispenser paddle.

  2  Keep the glass in this 

position until water 

comes out of the 

dispenser. It may 

  3  Continue dispensing 

water for about four 

(4) minutes to flush the

system and plumbing 

connections of any 

impurities (stopping to empty the glass as necessary).

After the refrigerator is installed properly and has cooled 

for several hours, the ice maker can produce ice within 

24 hours. The ice maker will fill the ice bin from the rear.

You must dispense some ice to force the ice forward in 

the bin. This will allow the bin to fill completely.

Ice production is controlled by the ice maker’s On/Off 

icon on the control panel. Press and hold the “Ice Off” 

icon for three (3) seconds to turn the ice maker “ON” or 

“OFF”.  The ice maker is turned off when the LED above 

the “Ice Off” icon is illuminated.

Before making ice for the first time, be sure to prime

the water supply system.  Air in new plumbing lines can 

result in two (2) or three (3) empty ice maker cycles. 

Furthermore, if the system is not flushed, the first ice

cubes may be discolored or have an odd flavor.



Dispensed water is chilled.  For colder water, add ice to 

cup or container before dispensing water.