Frigidaire FGUB2642LF ユーザーズマニュアル

22

1.  Begin filling the

tank by pressing 

and holding a 

drinking glass 

against the water 

dispenser paddle.

2.  Keep the glass in 

this position until 

water comes out 

of the dispenser. 

3.  Continue dispensing water for about 

four (4) minutes to flush the system

and plumbing connections of any 

impurities (stopping to empty the glass 

as necessary).

After the refrigerator is installed properly 

and has cooled for several hours, the ice 

maker can produce ice within 24 hours. The 

ice maker will fill the ice bin from the rear.

You must dispense some ice to force the ice 

forward in the bin.  This will allow the bin to 

fill completely.

Ice production is controlled by the ice maker’s 

On/Off icon on the control panel. Press and 

hold the “Ice Off” icon for three (3) seconds 

to turn the ice maker “ON” or “OFF”.  The ice 

maker is turned off when the LED above the 

“Ice Off” icon is illuminated.

Before making ice for the first time, be sure

to prime the water supply system.  Air in new 

plumbing lines can result in two (2) or three 

(3) empty ice maker cycles. Furthermore, if 

the system is not flushed, the first ice cubes

may be discolored or have an odd flavor.



The water dispenser has a built-in device that 

shuts off the water flow after three (3) minutes

of continuous use. To reset this shutoff device, 

simply release the dispenser paddle. 



Dispensed water is chilled.  For colder 

water, add ice to cup or container before 

dispensing water.



The ice maker also has a built-in plastic 
signal bale arm that automatically stops 
ice production when the ice bin is full. This 
signal arm should not be used to manually 
stop the ice maker.

For proper dispenser operation, recommended 

water supply pressure should fall between 

30 psi and 100 psi. Excessive pressure may 

cause water filter to malfunction.

Your ice maker is turned on at the factory 
so it can work as soon as you install your 
refrigerator. If you cannot connect a water 
supply, set the ice maker’s On/Off icon to 
Off and turn off the water supply valve; 
otherwise, the ice maker’s fill valve may make
a loud chattering noise when it attempts to 
operate without water.

Turning off the ice maker will result in 
existing ice melting in the bin.

Turning off the ice maker will disable the ice 

dispenser.  You will still be able to dispense water.