Frigidaire FGUB2642LP ユーザーズマニュアル

24

After the refrigerator is installed properly, the ice 

maker can produce ice within 24 hours. It can 

completely fill the ice bin in about three (3) days.
When using the ice maker for the first time and

in order for the ice maker to work properly, it is 

necessary to clear air from water filter tubing.

Once ice maker begins making ice, allow the 

bucket to fill completely, then discard the first TWO

(2) FULL buckets of ice.  It will take at least two 

(2) days to completely fill the bucket on regular ice

making mode or 1 

1

/

2

 days on fast ice mode.

The ice maker produces approximately four 2.5 

pounds of ice every 24 hours depending on  

usage conditions.  

Ice production is controlled by lifting/lowering 

the ice maker’s wire signal arm.  To gain 

access to the ice maker, pull the freezer drawer 

out.  Lift the wire signal arm to turn the ice 

maker OFF and lower the wire signal arm to 

turn it ON.

•  If your refrigerator is not connected to a 

water supply or the water supply is turned 

off, turn off the ice maker by lifting wire 

signal arm. 

Clean the ice maker and ice bin at regular 

intervals, especially prior to vacation or moving.

1.  Turn off the ice maker.
2.  Remove the ice bin. 
3.  Empty and carefully clean the ice bin 

with mild detergent. Do not use harsh 

or abrasive cleaners.  Rinse with clean 

water.

4.  Allow the ice bin to dry completely 

before replacing in the freezer.

5.  Replace the ice bin.  Turn the ice maker on.

Remove and empty the ice bin if:

•  An extended power failure (one hour or 

longer) causes ice cubes in the ice bin to 

melt and freeze together.

Remove the ice bin and shake to loosen the 

cubes or clean as explained above.

•  The following sounds are normal when the 

ice maker is operating:

 

-  Motor running  

 

 

-  Ice dropping into ice bin 

 

-  Water valve opening or closing

 

-  Running water

•  Ice cubes stored too long may develop an odd 

flavor. Empty the ice bin as explained below.

Quick Ice Function
Your refrigerator is equipped with a Quick Ice

Function, that increases ice production.  This 

function terminates automatically.

Your ice maker is turned on at the factory 

so it can work as soon as you install your 

refrigerator. If you cannot connect a water 

supply, lift the ice maker’s wire signal arm to 

turn it off. Otherwise, the ice maker’s fill valve

may make a loud chattering noise when it 

attempts to operate without water.

If the water supply to your refrigerator is 

softened, be sure the softener is properly 

maintained.  Chemicals from a water 

softener can damage the ice maker.  

NEVER use an ice pick or similar sharp 

instrument to break up the ice. This could 

damage the ice bin.
To loosen stuck ice, use warm water.  

Before replacing the ice bin, make sure it is 

completely dry.