Frigidaire 241856001 ユーザーズマニュアル

8

You can disable the cooling system in your refrigerator
by pressing the

On/Off button located on the left side of

the temperature control panel. To ensure that you do not
accidentally turn off the cooling system, the button does not
work unless you press and hold it for three seconds. Once you
disable the cooling system, all refrigeration to the freezer and
fresh food compartments stops. To turn the cooling system back
on, you must again press and hold the

On/Off button for three

more seconds.

Your refrigerator’s air filter needs to be replaced from time to
time. You can monitor the need for replacement by referring to
the status light while the air filter is “ON”. To turn on the air filter,
press the

AIR fILtER button. To turn off the air filter, press the

AIR fILtER button. To reset the air filter, press the AIR fILtER 
button and hold for 3 seconds.

In general, you should change the air filter every six months to
ensure optimal filtering of refrigerator odors. You may want to
adjust this time period depending on the types and amounts of
food you typically store in your refrigerator.
to replace your air filter:
  1  Push the plastic

bubble tab located
on the side of the
air filter housing.
This releases the
hinged bottom half
to drop open.

  2  Remove the old

filter and discard it.

To order new air filter cartridges, contact the dealer where
you bought your refrigerator, contact Electrolux Solutions
Hotline at 1-800-944-9044, or go to our web site at www.
frigidaire.com. It would be beneficial to order some
cartridges when you first install your refrigerator. Be sure and
ask for air filter replacement cartridge, part # 241504902.

Pressing the

On/Off button on the control panel disables your refrigerator’s cooling system but does not disconnect power to lights and

other electrical components. To turn off power to your refrigerator you must unplug the power cord from the wall outlet.

Each time you make settings on the control panel, a single audible tone acknowledges your input.

  3  Unpackage the new filter and place it inside the hinged

bottom half of the housing.

  4  Push the hinged bottom half upward until the tab snaps

into closed position.

  5  Press and hold the Filter Reset button on the electronic

control panel for 3 seconds. When the

filter OK light

comes on, the status has been reset.

  6  Press and hold the Filter Reset button for 3 seconds

again to turn off the filter status system.

Your refrigerator’s control system can convey the following
information through audible tones and the alarm indicator lights.

Green

Filter OK.

Yellow

Air filter is about 80 percent used. Please
order a new one.

Red

Air filter is 100 percent used. Please change
now.

Door

Ajar

Flashing

Green



Freezer or
refrigerator door
has been open for
over five minutes.

Close door
to disable
and reset
alarm.