Electrolux EW23BC71IS ユーザーズマニュアル

Your refrigerator is equipped with separate water and 
air filtering systems. The water filter system filters all 
dispensed drinking water, as well as the water used to 
produce ice. The air filter removes odors and impurities 
from the refrigerator compartment.

The control panel includes controls to monitor the 
status of your water and air filters. See the Controls 
section for more information.

The 

TM

 ice and water 

filter system is tested and certified 
by NSF International, the nationally 
respected, not-for-profit certification 
organization for public health safety. The 

TM 

ice and water filter system is tested 

and certified to ANSI/NSF Standards 42 and 53 for
the reduction of claims specified on the performance 
data sheet. 

Do not use with water that is microbiologically unsafe 
or of unknown quality without adequate disinfection 
before or after the system. Systems certified for cyst 
reduction may be used on disinfected waters that may 
contain filterable cysts. 

 •  Rated Capacity - 400 gallons for

TM

 ice and water filter

 •  Rated service flow - .5 gallons per minute
 •  Maximum Rated Pressure - 100 pounds per

square inch

 •  Recommended Minimum Operating Pressure:

30 pounds per square inch

 •  Operating Temp.: Min. 33°F, Max. 100°F

The water filter is located at the lower left side of the 
fresh food compartment. 

In general, you should change the water filter every 
six (6) months to ensure the highest possible water 
quality. The 

Water Filter Status light on the Touch 

Panel prompts you to replace the filter after a standard 
amount of water (400 gallons)

 

has flowed through the 

system.

If your refrigerator has not been used for a period of 
time (during moving for example), change the filter 
before reinstalling the refrigerator.

It is not necessary to turn the water supply off to 
change the filter. Be ready to wipe up any small 
amounts of water released during the filter replacement.

 

1  Turn Off the ice maker on the control panel.   

 

2   Push the filter release button above the cartridge 

to disconnect it.

 

3  Slide the old water filter cartridge straight out of 

the housing and discard it.

 

4  Unpack the new filter cartridge and remove the 

two (2) protective caps covering the inlet and exit 
of the filter.  Slide the filter gently into the housing 
until it stops against the snap-in connector at the 
back of the housing.