Electrolux ENB35405 S ユーザーズマニュアル

ページ / 40
26 electrolux
GB
Something N
Something N
ot W
ot W
orking
orking
If the appliance is not working correctly, please carry out the following checks before
contacting your local Service Force Centre.
Problem
No power to the
appliance
The temperature in the
fridge or freezer is too
high
The compressor runs
continuously
The temperature in the
fridge or freezer is too
low
Excessive frost and
ice has built up
The appliance is
noisy.
Possible Cause
No power at the socket.
There is a power cut.
The fuse has blown.
Thermostat control knob is set
at „0”.
The appliance is located in an
unsuitable position.
The thermostat control knob is
set too low.
The thermostat control knob is
set at the wrong temperature.
The door is open.
Large quantities of food have
been placed in the cabinet.
The door has been opened too
frequently.
The air ventilation is obstructed.
The thermostat control knob is
set too cold.
The door has been left open.
Something is obstructing the
door.
The door gasket is dirty.
The appliance is not level.
Solution
Check there is power at the
socket.
Check there is not a power cut
by checking the household
lights.
Check the fuse has not blown.
Check the thermostat setting.
Check the ambient temperature
is within the appliances operating
limits of 10 °C to 32 °C.
Check that the thermostat control
knob is turned to the correct
setting relative to ambient
conditions.
Adjust the thermostat control
knob.
Close the door.
Do not leave the door open
longer than necessary.
Check that the air ventilation is
not obstructed.
Set the thermostat control knob
to a warmer position.
Check the door has not been left
open.
Check nothing is preventing the
door from closing.
Check the door gasket is intact
and clean.
Check if the appliance stands
stable on the floor.
If after the above checks your appliance
still does not operate correctly, contact
your local Service Force Centre.
Please note that it will be necessary to
provide proof of purchase for any in-
guarantee service calls.
In-guarantee customers should
ensure that the above checks have
been made, as the engineer will
make a charge if the fault is not a
mechanical or electrical breakdown.