Maytag MFT2976AEB マニュアル

Troubles

hooting

Temperature and Moisture 

Sizzling

Water dripping on the heater during defrost cycle

This is normal.

Water running/Gurgling

May be heard when ice melts during the defrost cycle and 
water runs into the drain pan

This is normal.

Buzzing and Clicking

Heard when the water valve opens and closes to dispense 
water and/or fill the ice maker. 

If the refrigerator is connected to a 
water line, this is normal.

If the refrigerator is not connected to a 
water line, turn OFF the ice maker.

Repetitive Clicking

Dual evaporator valve regulating the cooling operation

You may hear rapid repetitive clicking 
sounds as the unit switches from 
cooling one compartment to cooling 
the other. This sound is normal. 

Creaking/Cracking/Grinding

May be heard as ice is being ejected from the ice maker 
mold

This is normal.

Clatter

May be heard when the ice falls into the ice storage bin

This is normal.

The refrigerator has just been 
installed.

Allow 24 hours following installation for the refrigerator to 
cool completely.

Cooling is turned off.

Turn on cooling. See “Using the Control(s).”

The controls are not set correctly for 
the surrounding conditions.

Adjust the controls a setting colder. Check the temperature in 
24 hours. See “Using the Control(s).”

The door(s) are opened often or not 
closed completely.

Allows warm air to enter refrigerator. Minimize door openings 
and keep doors fully closed.

A large load of food was recently 
added.

Allow several hours for refrigerator to return to normal 
temperature.

The refrigerator air vent(s) are blocked. If the air vent located in the top, left, rear corner of the 

refrigerator compartment is blocked by items placed directly 
in front of it, the refrigerator will get too cold. Move items 
away from the air vent.

The controls are not set correctly for 
the surrounding conditions.

Adjust the controls a setting warmer. Check the temperature 
in 24 hours. See “Using the Control(s).”

The ice storage bin is not in the 
correct position. 

See “Ice Maker and Ice Storage Bin.”

The control is not set correctly for the 
items stored in drawer.

Adjust the temperature setting. See “Temperature Controlled 
Drawer” in the “Refrigerator Features” section.

NOTE: Some moisture 
buildup is normal.

The room is humid 

A humid environment contributes to moisture buildup.

The door(s) are opened often or not 
closed completely.

Allows humid air to enter the refrigerator. Minimize door 
openings and close doors completely.

The door is blocked open

Move food packages away from door.

A bin or shelf is in the way

Push bin or shelf back into the correct position.

Storing liquid in open containers

This adds humidity to the refrigerator interior. Keep all 
containers tightly covered.

The drawer is opened often or left 
open.

Minimize drawer openings and close drawer completely after 
use.

Poor door seal 

Ensure door seals are making full contact with the 
refrigerator cabinet to allow for an adequate seal.

Temperature controls are not set 
correctly

See “Using the Control(s)” for recommended temperature 
settings.