Amana ZRRC8000 ユーザーズマニュアル

6

• Minimum clearance to rear wall is 0 inches.
• Minimum clearance to a vertical right or left side wall is

0 inches.

• Minimum clearance to counter top/cabinet on each side

is 0 inches.

• Minimum of 30 inches (76.2cm) between top of cooking

surface and bottom of an unprotected wood or metal
cabinet.

• 24 inches between cooking surface and protected wood

or metal cabinet above range. Cabinet bottom must be
protected by at least ¼ inch thick millboard with not
less than No. 28 MSG sheet steel, .015 inch thick
stainless steel, .024 inch thick copper.

A

B

C

D

E

A—30 inches (76.2cm) minimum
B—30 inches (76.2cm) unprotected/24 inches

(60.96cm) protected minimum

C—13 inches (33cm) maximum
D—25 inches (63.5cm) maximum
E—36 inches (91.4cm) maximum

Counter tops such as ceramic tile tops can cause cabinet
and counter top to be higher than 36 inches (91.4cm). Follow
instructions below when counter top is higher than 36 inches
(91.4cm).

1. Raise leveling legs to maximum level.
2. Measure from floor to range top. If measurement is

less than height of counter top floor must be
shimmed.

3. Shim floor using a piece of plywood same size as

range opening.  Secure plywood to floor. Plywood
must be as secure as original flooring.

4. Install anti-tip bracket and slide range into place.

• See “Anti-tip Bracket Installation” section.

Line voltage must not exceed rated voltage. Line voltage
less than rated voltage will result in slow heating.  Wiring
system must conform to C.S.A standards and Canadian
Electrical Code-latest edition. Installation must conform to
all local, municipal and state building codes, and local utility
regulations. Range must be connected only to a supply circuit
as specified on range name plate.

This range requires 4 wires, 120/240 Volts, 60 Hertz A.C.
See rating plate attached to range for kilowatt rating.
House wiring and fusing must comply with local wiring
codes. If no codes apply, wire according to Canadian
Electrical Code-latest edition.

Shaded areas show range clearance for electrical
connection. Power cord is supplied with range.

A

B

C

D

A—3 inches (7.6cm)
B—7 inches (17.8cm)
C—6 inches (15.2cm)
D—30

1

/

8

 to 30¼ inches (76.5cm to 76.8cm)