Amana ZRTSC8650* ユーザーズマニュアル

ページ / 64
29
Before Calling for Service
Common Questions
Should the oven maintain a constant temperature on an
oven thermometer?
• To maintain a temperature for baking, the oven
cycles on and off. The temperature may vary up to
25°F higher or lower than the oven temperature set
on the control.
Is there a problem if the oven smokes the first few times it
is turned on?
• Some minor smoking is normal when using oven
first few times.
Should there be an odor or smoke while self-cleaning the
oven?
• There may be some smoke and odor during the first
few cleaning cycles. If there is excessive smoke or
odor, too much soil remains in the bottom of the
oven. If the oven smokes excessively, turn off the
oven, wait for the oven to cool and wipe away the
excess soil. Reset the clean cycle.
Can the timer be used during automatic cooking?
• The timer can be used any time. The timer
functions independently from the oven cooking
functions. Always cancel the timer using TIMER
ON/OFF pad to avoid canceling the cooking
function.
Service Tones and Codes
Electronic range control has a self-diagnostic system.
Self-diagnostic system sounds a series of short, rapid
beeps and shows a “F-code” in display when there is a
problem. When electronic range control signals a
problem, follow steps listed below.
1. Record “F-code” shown.
• F1—pad malfunction.
• F2—high oven temperature.
• F3—temperature sensor malfunction.
• F4—temperature circuit malfunction.
• F5—control malfunction.
• F9—door switch sensor malfunction or oven door
not completely closed.
2. Disconnect electrical supply.
• Pressing TIMER ON/OFF pad or disconnecting
electrical supply may eliminate “F-code”. If failure
continues, contact an authorized servicer.
3. Contact an authorized servicer to check range.
Problem
Check
Oven light not
working
Check for loose bulb.
Check for burned out bulb; replace
with 40 watt appliance bulb.
Oven not
heating
Confirm range is plugged in.
Check for tripped circuit breaker.
Oven door will
not open
Wait for oven to cool. Door latch will
release automatically. Unlatch door
when cool.
Range top
gets warm
during use
This is normal.
Oven
temperature is
not accurate
Store bought oven thermometers do
not measure oven temperature
accurately. An accurate digital
thermometer is necessary to calibrate
oven.
Check for blocked heat vents.
Aluminum foil alters oven
temperature.
Confirm correct utensil is used for
cooking.
Longer
convection
cooking times,
convection fan
not running, or
F9 shows in
display.
Oven door not completely closed.
Oven element
cycles on and
off
This is normal when baking or
roasting.
Adjusting Thermostat
Oven temperature has been factory calibrated and tested.
In unlikely event that oven consistently overcooks or
undercooks food, make following adjustment.
1. Push 
BAKE pad.
2. Push   or   until an oven temperature greater than
500°F displays.
3. Immediately push and hold 
BAKE pad until “00”
displays, approximately 5 seconds.
4. To decrease oven temperature (for a cooler oven),
Push   or   until negative numbers appear. Oven
can be adjusted from -05° to -35° lower. To avoid over
adjusting oven move temperature -5° each time.
5. To increase oven temperature (for a warmer oven),
Push   or   until positive numbers appear. Oven can
be adjusted from 5° to 35° higher. To avoid over
adjusting oven move temperature 5° each time.
6. Push 
OVEN CANCEL button. Temperature
adjustment will be retained even through a power
failure.