Amana ZRTSC8650* ユーザーズマニュアル

8

To reduce risk of range tipping, secure range with a
properly installed anti-tip bracket.

1. Remove storage drawer from range.

• See “Removing Storage Drawer” section.

2. Unscrew leveling legs so when range is moved into

position range top clears counter top.
  • Left or right rear leveling leg must extend at least ¼

inch (6mm) to engage bracket.

• Anti-tip bracket can be installed on either right or left

rear leveling leg.

or

3. Move range to where it will be installed.
4. Position anti-tip bracket.

• With range in position, reach through storage

drawer opening and slide anti-tip bracket on either
left or right rear leveling leg. Slide leg into V-shaped
notch in bracket.

5. Mark location of side and front of anti-tip bracket on

floor.

6. Remove anti-tip bracket and range from opening.
7. Position anti-tip bracket according to lines marked on

floor.

8. Mark 2 hole locations in anti-tip bracket.
9. Drill 2 holes.

• If drilling into wood, use a 

 inch drill bit.

• If drilling into concrete, use a 

 inch masonry drill

bit and insert plastic anchors.

10. Secure bracket to floor using screws supplied.
11. Slide range into position.

• See “Level Range” section of manual.

12. Confirm anti-tip bracket is engaged with range leveling

leg and replace storage drawer.

Shaded areas show range clearance for electrical
connection. Power cord is supplied with range.

A

B

C

D

A—3 inches (7.6cm)
B—7 inches (17.8cm)
C—6 inches (15.2cm)
D—30

1

/

8

 to 30¼ inches (76.5cm to 76.8cm)