Frigidaire 318205854 ユーザーズマニュアル

36

Poor installation. Place oven rack in center of oven. Place a level on the oven rack. Adjust leveling legs 

at base of range until the rack is level. When range is level, cooktop may appear out of alignment if 

countertop is not level.
Weak, unstable floor. Be sure floor is level and can adequately support range. If floor is sagging or 

slopping, contact a carpenter to correct the situation.
Kitchen cabinet misalignment may make range appear to be unlevel. Be sure cabinets are square and 

have sufficient room for range clearance.

Cabinets not square or are built in too tight. Contact a cabinet maker to correct the problem.
Contact builder or installer to make appliance accessible.
Carpet interferes with range. Provide sufficient space so range can be lifted over carpet.
Gas line is hard-plumbed. Have a flexible C.S.A international approved metal appliance connector 

installed.

Make sure cord/plug is plugged tightly into outlet.
Service wiring is not complete. Call an authorized servicer.
Electrical power outage. Check house lights to be sure. Call your local electric company for service.

Electronic control has detected a fault condition. Press cancel to clear the display and stop beeping. 

Reprogram oven. If fault recurs, record fault number. Press cancel and call an authorized servicer for 

assistance.

Replace or tighten bulb. See Changing Oven Light section in this Use & Care Guide.   
Electrical power outage. Check house lights to be sure. Call your local electric company for service.

Surface Control knob has not been completely turned to LITE. Push in and turn the Surface 

Control knob to LITE until burner ignites and then turn control to desired flame size.
Be sure gas supply valve is open.
Burner ports or slots are clogged. With the burner off, use a small-gauge wire or needle to 

clean ports or slots.
Power cord is disconnected from outlet (electric ignition models). Be sure cord is plugged 

securely into outlet.
Electrical power outage (electric ignition models). Burners can be lit manually. See Setting 

Surface Controls in this Owner’s Guide.

Burner ports or slots are clogged. With the burner off, clean ports with a small-gauge wire or 

needle to clean ports or slots.
Moisture is present after cleaning. Lightly fan the flame and allow burner to operate until flame 

is full. Dry the burners thoroughly following instructions under General Cleaning. 

Dust particles in main line. Allow the burner to operate a few minutes until flame turns blue. 
In coastal areas, a slightly orange flame is unavoidable due to salt air.

Many factors affect baking results. Make sure the proper rack position is used. Center food in the 

oven and space pans to allow air to circulate. Allow the oven to preheat to the set temperature before 

placing food in the oven. Try adjusting the recipes’ recommended temperature or baking time. If you 

feel the oven is too hot or cool, see "Adjusting Your Oven Temperature" section in the Electronic Oven 

Control Guide.

A cooling fan may automatically turn on and off to cool internal parts. It is normal, and the fan may 

continue to run even after oven is turned off.

Before you call for service, review this list. It may save you time and expense. The list includes common 

occurrences that are not the result of defective workmanship or materials in this appliance.