Electrolux A02992401 オーナーマニュアル

ページ / 48
37
•  To avoid possible burns use care when 
opening the oven door after the Self-Cleaning 
cycle. Stand to the side of the oven when 
opening the door to allow hot air or steam to 
escape.
•  DO NOT force the oven door open. This can 
damage the automatic door locking system. 
Use caution and avoid possible burns when 
opening the door after the Self-Cleaning cycle 
has completed. The oven may still be VERY 
HOT.
Setting self-clean
The SELF CLEAN pad controls the Self-Cleaning 
feature. When used with a the Delay Start pad, 
a delayed Self-Cleaning cycle may also be 
programmed. The Self Clean feature allows for any 
Self-Cleaning cycle time from 2 (2:00) to 4 hours 
(4:00). You may also choose the clean time in 1 
minute increments (for example 2 hours and 50 
minutes) by pressing the corresponding number 
keypads.
If you are planning to use the oven directly after 
a self-clean cycle remember to allow time for the 
oven to cool down and the oven door to unlock.  
This normally takes about one hour.  So a 3 hour 
self-clean cycle will actually take about 4 hours to 
complete.
*It is recommend to use a 2 hour self-clean cycle 
for light soils, a 3 hour cycle for average soils, 
and a 4 hour cycle for heavy soils (to assure 
satisfactory results).
See example below to start an immediate Self-
Cleaning cycle or to set a Delay Start time of 
8:00 o’clock and shut-off automatically (example 
provided is a default 3 hour Self-Clean cycle)
Example
Step
  
Press
1.  Be sure the clock is set with the correct time
 
of day, the oven is EMPTY and the oven door
 is 
closed.
2. Press SELF CLEAN
 
The control will automatically clean for a 3 hour 
period (default self-cleaning cycle time). Note: If a 
2 or 4 hour clean time is desired, press 2 0 0 for 2 
hour or press 4 0 0 for a 4 hour clean time. Set the 
cleaning time based on the amount of soil: light, 
medium or heavy (*See above).
Note: If the optional delay Self-Clean feature is 
needed, fi nish steps 3-4.
3. Press DELAY START
 
4.  Enter the desired Self-Clean
 
starting time using the number 
 
pads 8 0 0.
 
 
 
5. Press START
 
Setting Self-Clean Cycle
 
NOTE
You may press CANCEL any time during the 
cleaning process. After cancelling the self-clean 
cycle, do not attempt to open the oven door until 
the DOOR lock icon turns off.
 
NOTE
The kitchen area should be well ventilated using 
an open window, ventilation fan or exhaust 
hood during the Self-Clean cycle. This will help 
eliminate the normal odors associated with the 
Self-Clean cycle.
 
NOTE
Allow about 15 seconds for the oven door lock to 
close.
As soon as the control is set, the motor driven 
oven door lock will begin to close automatically. 
Once the door has been locked the “DOOR 
LOCKED” indicator light will stop fl ashing and 
remain on.
The control will calculate forward from the set 
start time to determine when the Self-Cleaning 
cycle should end. The Self-Cleaning cycle will 
turn on automatically at the set time.
 
IMPORTANT
•  If a self-clean cycle was started but did not 
fi nish due to a power failure, your oven may 
not be completely cleaned. After power has 
been restored and the oven door has unlocked, 
set for another self-clean if needed.
•  The oven will need to cool down before starting 
another self-clean cycle. The oven controls will 
force a delay of 4 hours between cycles.
When the Self-Clean Cycle is Completed
Once the oven has cooled down for approximately 1 
HOUR, and the “DOOR LOCKED” icon is no longer 
displayed, the oven door can then be opened.