Wolf WSPR2F プリント

F-39065 (04-07)

BASIC MODELS:
WSPR1 

One section, 18" wide x 24.5" deep

WSPR2 

Two sections, 36" wide x 24.5" deep

WSPR2F 

Two sections, 18" wide x 49" deep

KEY FEATURES:
➤

  Stainless steel front and sides. Legs finished in black epoxy 

powdercoat paint.

➤

  Heavy cast iron top grate(s).

➤

  Two concentric 55,000 BTU/hr ring-type burners per 18" 

section; 110,000 BTU/hr input per section.

➤

  Standing pilot ignition system.

➤

  Two infinite heat control valves per section.

➤

  Heat shield to protect control valves.

➤

  3/4" rear gas connection and gas pressure regulator per 

section (only one for WSPR2F).

➤

  One year limited parts and labor warranty.

➤

  Stainless steel legs.

INSTALLATION REQUIREMENTS:
1.  A gas pressure regulator sized for this unit was included. 

Natural Gas 5" W.C., Propane Gas 10" W.C.

2.  Gas line connecting to appliance must be 3/4" diameter or 

larger. If flexible connectors are used, the inside diameter 
must be the same as the 3/4" pipe. 

3.  An adequate ventilation system is required for commercial 

cooking equipment. Information may be obtained by writing 
to the National Fire Protection Association, 1 Batterymarch 
Park, Quincy, MA 02169, www.NFPA.org. When writing refer 
to NFPA No. 96.

4.  These units are manufactured for installation in accor-

dance with National Fuel Gas Code, ANSI-Z223.1/NFPA 
#54 (latest edition). Copies may be obtained from The 
American Gas Association, Accredited Standards Com-
mittee Z223 @ 400N. Capital St. NW, Washington, DC 
20001, or the Secretary Standards Council, NFPA, 1 Bat-
terymarch Park, Quincy, MA 02169-7471.
NOTE: In the Commonwealth of Massachusetts

 

All  gas  appliances  vented  through  a  ventilation  hood  or 
exhaust system equipped with a damper or with a power 
means of exhaust shall comply  with 248 CMR.

5.  Clearances:
 

 

Combustible 

Non-Combustible

 

Rear 

24" 

4"

 

Sides 

18" 

0"