Furuno FR-8125 ユーザーズマニュアル

1.  OPERATION

You can use this radar as a remote display when you set [Input Source] to [Slave] on 
the [Installation] sub menu. When this setting is done, the menu and display change 
as described below. To display the radar image on the remote display, transmit from 
the main radar.

Note:  The message "Please turn to STBY-mode when you change this setting." ap-
pears when you switch the mode in transmission.

The menu items not available with the remote display are shown in the table.

The display changes as shown in the following illustration.

•  [Pulse Length] ([Echo] menu)
•  [2nd-Echo Rejector] ([Echo] menu)
•  [Watchman] ([Alarm] menu)
•  [Tuning Mode] ([Tuning] menu)

The total TX time (TX TIME XXXXXX.XH) does not appear on the diagnostic test or 
on the Normal standby display.

[Echo]

[Pulse Length], [2nd Echo Rejector]

[Custom 1, 2, 3]

[Pulse Length]

[Alarm]

[Watchman]

[Tuning]

All menu items are not accessible.

[System] - [Sector Blanks]

All menu items are not accessible.

[System] - [Installation]

[Antenna Rotation], [MBS Adjust], [Auto Install Setup], 
[Total TX Time]

H D G

OFFCENT(M)       

Shown when display
unit functions as
remote display.

Tuning indicator
is not displayed.

Pulselength 
is not displayed.

WTC is not displayed.

SLAVE

0.5

NM

0.125

C S 1

H   U P

TRAIL(T)

06MIN

ALM1_ACK
ALM2_OUT

3 5 9 . 9 °