Radio Shack 21-1703 A ユーザーズマニュアル
7
Setup
Connecting the Microphone
1.
Press the tab on the side of the supplied microphone’s plug and insert the
plug into the MIC jack on the front of the transceiver. Be sure the tab is
aligned with the jack’s notch.
plug into the MIC jack on the front of the transceiver. Be sure the tab is
aligned with the jack’s notch.
2.
Slide the microphone onto the microphone holder.
To disconnect the microphone from the transceiver, press the tab on the side of
the plug. Then pull out the plug.
the plug. Then pull out the plug.
Caution: To avoid damaging the microphone, never pull on the microphone
microphone, never pull on the microphone
, never pull on the microphone
cable.
Connecting an External Speaker
Your transceiver also can be connected to an external CB speaker (not supplied).
Note: When you connect an external speaker, the CB’s internal speaker
disconnects.
disconnects.
The external speaker you use with the transceiver should have an impedance of
8 ohms and be able to handle 3 to 10 watts of power. The speaker cable must
have a
8 ohms and be able to handle 3 to 10 watts of power. The speaker cable must
have a
1
/
8
-inch (3.5mm) plug. Your local RadioShack store carries a variety of
speakers and cables to meet your needs.
To connect the external speaker to the transceiver, insert the speaker cable’s
plug into the EXT SPEAKER jack on the back of the CB.
plug into the EXT SPEAKER jack on the back of the CB.
Tab
Notch