Vertex Standard VX-3200V ユーザーズマニュアル

This alignment tool consists, MS-DOS based, only one ex-

ecute file “svc52.exe.“ You make a directly as you think

fit, and copy this file. That is all of the installation pro-

cess.
Boot the tool

Change directly and input in command line, “svc52 [en-

ter],“ and boot the alignment tool.
Preparation

Setup the test equipment as “Alignment Preparation &

Precautions.”
Set the Ch. List to Table 1 on the CE52 Clone editor soft-

ware.

To enter the alignment mode, press “[0] Alignment Mode”

on the personal computer Key board. You turn off the

power of the transceiver, and turn on the transceiver. If

entry succeed,the alignment tool display as follows.

   [0]Common TX

   [1]Common RX

When the transceiver is in alignment mode, the action of

[PTT], [MON], [UP], and [DOWN] is ignored. All of the

action is remote controlled by PC.

This parameter is used to align TX High power (50 W).

¦

Press [Enter] on “[0] Tx Power High” to align

TX High power.

¦

Select the Channel “1“ in alignment range.

¦

Press the [Space] key on the keyboard to acti-

vate the transmitter.

¦

Press the [UP] or [DWN] key, as needed, to set

the power output to the following specification,

as indicated on the external wattmeter.

Tx Power High: 50 W (±1.0 W)

¦

When the 50 Watt level is attained, press [Enter]

to lock in the new data.

This parameter is used to align TX Low power (10 W).

¦

Press [Enter] on “[1] Tx Power Low” to align TX

Low power.

¦

Select the Channel “1“ in alignment range.

¦

Press the [Space] key on the keyboard to acti-

vate the transmitter.

¦

Press the [UP] or [DWN] key, as needed, to set

the power output to the following specification,

as indicated on the external wattmeter.

Tx Power Low: 10 W (±0.5 W)

¦

When the 10 Watt level is attained, press [Enter]

to lock in the new data.

This parameter is used to align the VCO Deviation.

¦

Press [Enter] on “[2] VCO Deviation” to align

VCO Deviation.

¦

Select the Channel “1“ in alignment range.

¦

Adjust the AF generator output level to

388mVrms (–6dBm) at 1 kHz to the pin 3 of the

J1502 (D-sub 9pin ).

¦

Press the [Space] key on the keyboard to acti-

vate the transmitter.

¦

Press the [UP] or [DWN] key, as needed, to set

the VCO Deviation (Wide) to the following speci-

fication, as indicated on the deviation meter.

¦

When the desired deviation level is attained,

press [Enter] to lock in the new data.

¦

Select the Channel 2, and set the VCO Deviation

(Narrow), same as Channel “1.“

VCO Deviation (Wide): 4.0 kHz (±0.1 kHz)

VCO Deviation (Narrow): 2.0 kHz (±0.1 kHz)