Vertex Standard FT-2000 ユーザーズマニュアル

Page 119

FT-2000 O

PERATING

 M

ANUAL

MODE-RTY G

ROUP

076 rtty R PLRTY

Function: Selects normal or reverse Mark/Space polarity
for RTTY receive operation.
Available Values: nor/rEU
Default Setting: nor

077 rtty T PLRTY

Function: Selects normal or reverse Mark/Space polarity
for RTTY transmit operation.
Available Values: nor/rEU
Default Setting: nor

078 rtty RTY OUT

Function: Selects the receiver to be connected to the data
output port (pin 1) of the RTTY jack.
Available Values: nAin (Main)/Sub (Sub)
Default Setting: nAin (Main)

079 rtty OUT LEL

Function: Sets the FSK RTTY data output level at the
output port (pin 1) of the RTTY jack.
Available Values: 0 ~ 100
Default Setting: 50

080 rtty SHIFT

Function: Selects the frequency shift for FSK RTTY op-
eration.
Available Values:170/200/425/850 Hz
Default Setting: 170 Hz

081 rtty TONE

Function: Selects the Mark tone for RTTY operation.
Available Values: 1275/2125 Hz
Default Setting: 2125 Hz

M

ENU

 M

ODE

MODE-FM G

ROUP

072 F3E MICGAIN

Function: Sets the microphone gain for the FM mode.
Available Values: Ur/0 ~ 100
Default Setting: 50
When this menu is set to “Ur,” you may adjust the micro-
phone gain using the front panel’s [MIC] knob.

073 F3E MIC SEL

Function: Selects the microphone to be used on the FM
mode.
Available Values: Frnt/dAtA/PC
Default Setting: Frnt

Frnt (FRONT): Selects the microphone connected to

the front panel’s MIC jack while us-
ing the FM mode.

dAtA:

Selects the microphone connected to
pin 1 of the PACKET Jack while us-
ing the FM mode.

PC:

This parameter is for future expansion
of this transceiver’s capabilities, but
at this time is not supported.

074 F3E 28 RPT

Function: Sets the magnitude of the repeater shift on the
28 MHz band.
Available Values: 0 ~ 1000 kHz (10 kHz/step)
Default Setting: 100 kHz

075 F3E 50 RPT

Function: Sets the magnitude of the repeater shift on the
50 MHz band.
Available Values: 0 ~ 4000 kHz (10 kHz/step)
Default Setting: 1000 kHz