Vertex Standard VX-8R ユーザーズマニュアル

VX-8R O

PERATING

ANUAL

REQUENCY

AVIGATION

The VX-8R will initially be operating in the “VFO” mode, as just described. This is a frequency
step system which allows free tuning throughout the currently-selected operating band.

Three basic frequency navigation methods are available on the VX-8R:

1) T

UNING

IAL

Rotation of the DIAL knob allows tuning in the pre-pro-
grammed steps established for the current operating band.
Clockwise rotation of the DIAL knob causes the VX-8R to
be tuned toward a higher frequency, while counter-clock-
wise rotation will lower the operating frequency.

If you press the

key briefly, then rotate the DIAL knob,

frequency steps of 1 MHz will be selected. This feature is
extremely useful for making rapid frequency excursions over the wide tuning range of the
VX-8R.

2) D

IRECT

EYPAD

REQUENCY

NTRY

The desired operating frequency may be entered directly from the keypad.

The operating mode will automatically be set once the new frequency is entered via the
keypad.

To enter a frequency from the keypad, just press the numbered digits on the keypad in the
proper sequence. There is no “Decimal point” key on the VX-8R, so if the frequency is below
100 MHz (e.g. 15.150 MHz), any required leading zeroes must be entered. However, there is
a short-cut for frequencies ending in zero - press the

key after the last non-zero digit.

Examples:
To enter 146.520 MHz, press

To enter 15.255 MHz, press

To enter 1.250 MHz (1250 kHz), press

To enter 0.950 MHz (950 kHz), press

To enter 430.000MHz, press

PERATION