Vertex Standard VM-3500E ユーザーズマニュアル
Page 15
VM-3500E
6.10 OPTIONAL ENHANCED RAM+ SECOND STATION MIC INSTALLATION
The VM-3500E is capable of using an Enhanced RAM+ MIC to remotely con-
trol the Radio, DSC and PA/Fog functions. In addition the VM-3500E can oper-
ate as a full function intercom system.
trol the Radio, DSC and PA/Fog functions. In addition the VM-3500E can oper-
ate as a full function intercom system.
1. Connect the RAM+ MIC Cable to the RAM MIC CONNECTOR on the rear
panel, then tighten the Cable Nut (See Figure 3).
2. Referring to Figure 3, make a 30 mm hole in the wall, then insert the RAM+
MIC Cable into this hole. Connect the Gasket and Mount Base to the RAM+
MIC Cable Connector using the Nut.
MIC Cable Connector using the Nut.
3. Drill the four Screw holes (approx. 2 mm) on the wall, then install the Mounting
Base to the wall using four screws.
4. Put the Rubber Cap on to the Nut. The installation is now complete.
5. Wires for a external speaker are privided on the RAM+ mic cable. Connect
5. Wires for a external speaker are privided on the RAM+ mic cable. Connect
any 8 Ohm extenal speaker. When connected the RAM+ controls the vol-
ume level of this speaker.
ume level of this speaker.
RAM+ or External Speaker Selection
By default the RAM+ internal speaker is turned on, however using the RAM+
mic this speaker can be turned off so the extenal speaker can be used.
mic this speaker can be turned off so the extenal speaker can be used.
1. Press and hold the [CALL/SET] key on the RAM+ Mic.
2. Using the [
2. Using the [
] or [] keys to select “
RAM
SPK
” and press the [CALL/SET] key.
3. Press the [
] or [] key to turn the RAM+
Speaker “
oF
.”
4. Press the [16/9] key to exit this mode.
Figure 3. Enhanced RAM+ MIC Installation
Wall
Gasket
Mounting Bracket
RAM MIC Cable
Cap
Nut
EXP SP Cable for the RAM+ MIC