Uniden UM380BK ユーザーズマニュアル

27

English

channel switching. If you receive an individual call, the radio will respond with an 

unattended code, just as if the radio were in Standby. 

1.  Press and hold 

 to display the normal menu. 

2.  Select Setup and then Auto CH SW. 

3.  Choose Off and press 

. The radio will not automatically switch channels until 

you reactivate this feature. 

#

If you have unread incoming DSC calls, the radio displays a message icon. You will be able 

to review who has called. The radio displays the last 10 distress calls and the last 20 non-

distress calls it received (see the receive log on page 28). 

Your radio can sit at any angle in the mounting bracket so it can easily accommodate the best 

location. First, determine the best place to mount the radio. For optimum performance, find a 

location that can: 

 x

Properly support the weight of the radio, approximately 2.2 pounds or 1.0 kilograms. 

You may need to use some type of anchor with the mounting screws to hold the radio, 

depending on the surface. 

 x

Keep the battery leads as short as possible. 

 x

Keep the antenna lead-in wire as short as possible. 

 x

Allow free air flow around the heat sink on the rear of the radio. 

 x

Avoid interference with the ship’s compass. 

1.  Install the radio into the mounting bracket. 

2.  Position the radio into 

the desired location. 

Mark the edges of the 

bracket on the mounting 

surface. 

3.  Remove the mounting 

bracket drill template 

from the back of the 

manual, and use the 

template to mark 

the drill holes on the 

mounting surface. 

4.  Drill the holes for the 

mounting bracket; 

be sure to follow any 

special requirements of the mounting surface.

Step 1: 
Slide the radio 
into the mounting 
bracket.

Step 2: 
Tighten the mounting knobs 
to secure the radio in place.