Mitsubishi Electronics TM-RFM ユーザーズマニュアル
1. FUNCTIONS AND CONFIGURATION
1 - 7
(2) MR-J3-350B-RJ080W
Connector for manufacturer setting (CN2L)
Not used for this servo amplifier.
Not used for this servo amplifier.
SSCNET cable connector (CN1B)
Used to connect the rear axis servo amplifier. For the final
axis, puts a cap.
Used to connect the rear axis servo amplifier. For the final
axis, puts a cap.
SW2
8
7
6
5
4
3
2 1 0 F
E
D
C
B
A
9
2
Display
The 3-digit, seven-segment LED shows the servo
status and alarm number.
Rotary axis setting switch (SW1)
The 3-digit, seven-segment LED shows the servo
status and alarm number.
Rotary axis setting switch (SW1)
Used to set the axis No. of servo amplifier.
SW1
Test operation select switch (SW2-1)
Used to perform the test operation
mode by using MR Configurator.
Used to perform the test operation
mode by using MR Configurator.
For manufacturer setting (Be sure to set
to the "Down" position).
to the "Down" position).
Main circuit power supply connector (CNP1)
Connect the input power supply.
Connect the input power supply.
USB communication connector (CN5)
Connect the personal computer.
Connect the personal computer.
I/O signal connector (CN3)
Used to connect digital I/O signals.
More over an analog monitor is output.
Used to connect digital I/O signals.
More over an analog monitor is output.
Control circuit connector (CNP2)
Connect the control circuit power supply/regenerative
option.
Connect the control circuit power supply/regenerative
option.
SSCNET cable connector (CN1A)
Used to connect the servo system controller or the front
axis servo amplifier.
Used to connect the servo system controller or the front
axis servo amplifier.
Direct drive motor power output connector (CNP3)
Connect the direct drive motor.
Connect the direct drive motor.
Encoder connector (CN2)
Used to connect the direct drive motor encoder.
Used to connect the direct drive motor encoder.
Charge lamp
Lit to indicate that the main circuit is charged. While this
lamp is lit, do not reconnect the cables.
Protective earth (PE) terminal ( )
Ground terminal.
Lit to indicate that the main circuit is charged. While this
lamp is lit, do not reconnect the cables.
Protective earth (PE) terminal ( )
Ground terminal.
Rating plate
1
Refer to the
MR-J3- B
Servo
Amplifier
Instruction
Manual.
Section 3.2
Section 3.3
Section 3.2
Refer to the
MR-J3- B
Servo
Amplifier
Instruction
Manual.
Chapter 2
Section 3.2
Section 3.2
Section 1.4
Name/Application
Detailed
explanation
B
7
9
6
8
5
4
3
2
1
0
F
E
D
C
A
1
2
ON 4E
SW1
SW2
TEST
Cooling fan
Fixed part
(3 places)
(3 places)
Battery holder
Install the battery MR-J3BAT.
Install the battery MR-J3BAT.
Refer to the
MR-J3- B
Servo
Amplifier
Instruction
Manual.
Battery connector (CN4)
Used to connect the battery for absolute position data
backup.
Used to connect the battery for absolute position data
backup.
Chapter 2
Section 3.4
Chapter 9