Multiquip CV2a/2B ユーザーズマニュアル
page 12 — CV seRIes VIbRatoR motoR • opeRatIon and paRts manual — ReV. #0 (04/30/13)
safety inforMation
Before plugging the motor into a power source,
alWaYs
remove any wrenches or other tools from the motor,
shaft, and head that were used for assembly.
power Cord/Cable safety
dangeR
alWaYs use a grounded 3-wire extension cord that has
a 3-prong grounding plug, and a 3-pole receptacle that
accepts the plug on the concrete vibrator motor.
do not
RemoVe tHe gRoundIng pIn FRom tHe plug!
neVeR let power cords or cables lay in water.
neVeR use damaged or worn cables or cords when
connecting equipment to generator. Inspect for cuts in
the insulation.
neVeR grab or touch a live power
cord or cable with wet hands. The
possibility exists of
electrical shock,
electrocution or death.
Make sure power cables are securely connected.
Incorrect connections may cause electrical shock and
damage to the vibrator motor.
CautIon
Ensure that cables and cords will not be tripped over.
NOTICE
alWaYs make certain that proper power or extension
cord has been selected for the job.
Use only extension cords that are intended for outdoor
use and so marked.
Use only the gauge wire and length of cord recommended
for the motor size. If in doubt, go to the next heavier gauge.
(The smaller the gauge number, the heavier the cord.)
enVIRonmental saFetY/deCommIssIonIng
NOTICE
do not pour waste or oil directly onto the ground, down
a drain or into any water source.
Contact your country's Department of Public Works or
recyling agency in your area and arrange for proper
disposal of any electrical components, waste or oil
associated with this equipment.
When the life-cycle of this equipment is
over it is recommended that the head
casing and all other metal parts be sent
to a recycling center.