Carson SA-441-17 ユーザーズマニュアル

SA-441-17  Installation and Operating Instructions 

Page 5 of 15 

 

 

07/29/08 

CP5008A 

 

Proper installation of the unit is essential for years of safe, reliable operation.  Please read all 
instruction  before installing the unit.  Failure to follow these instructions can cause serious 

damage to the unit or vehicle and may void warranties. 

For the safety of the installer, vehicle operator, passengers and the community please observe 
the following safety precautions.  Failure to follow all safety precautions and instructions 
may result in property damage, injury or death. 
Qualifications - The installer must have a firm knowledge of basic electricity, vehicle electrical 

systems and emergency equipment. 

 

- Sound level from siren speaker (>120dBA @ 10 feet) may cause hearing damage.  

Do not operate siren without adequate hearing protection for you and anyone in immediate vicinity. 

 

(Ref. OSHA 1910.95 for occupational noise exposure guidelines) 

 
Mounting - Mount the control head for easy access by the vehicle operator.  DO NOT mount 

in air bag deployment area.  Assure clearances before drilling in vehicle. 
Wiring - Use wiring capable of handling the current required.  Make sure all connections are 

tight.  Route wiring to prevent wear, overheating and interference with air bag deployment.  

Install and check all wiring before connection to vehicle battery. 
Testing - Test all siren functions after installation to assure proper operation.  Test vehicle 

operation to assure no damage to vehicle. 
Keep These Instructions - Keep these instructions in the vehicle or other safe place for future 

reference.  Advise the vehicle operator of the location. 

UNPACKING 
Inspect contents for shipping damage.  If found alert carrier immediately. 

Contact supplier immediately if any components are missing. 

Contents should include the following items: 

 

Complete Unit 

1 

Amplifier, Remote   (SA-441-17F or FX) 

X 

X 

1 

Bracket, Microphone Clip with mounting screws   (CP3633) 

X 

X 

1 

Connector, 10-P Terminal Block Plug for Amplifier   (CP4833-10) 

X 

X 

1 

Cable Assembly for Control Head, 5-P   (CP3040) 

X 

X 

1 

Control Head with attached Microphone   (SA-441-17CH) 

X 

 

1 

Control Head without Microphone   (SA-441-17CHX) 

 

X 

1 

Cable, Microphone Extension 18FT   (CP3850) 

 

X 

1 

Microphone, Detachable Noise Cancelling   (ES00028-10) 

 

X 

1 

Instruction Manual   (CP5008   This Manual) 

X 

X 

 

Amplifier Only 

1 

Amplifier, Remote Only   (SA-441-17AMP) 

1 

Connector, 10-P Terminal Block Plug for Amplifier   (CP4833-10) 

1 

Instruction Manual   (CP5008   This Manual)