Mitsubishi Electronics FR-V540-1.5K to 55K ユーザーズマニュアル

14

On the inverter primary side, it is recommended to provide an MC for the following purposes.
(

 Refer to the Instruction Manual (basic) for selection.)

1)

To release the inverter from the power supply when the inverter protective function is activated or the drive 
becomes faulty (e.g. emergency stop operation)

 

When cycle operation or heavy-duty operation is performed with an optional brake resistor connected, 
overheat and burnout of the discharging resistor can be prevented if a regenerative brake transistor is 
damaged due to insufficient heat capacity of the discharging resistor and excess regenerative brake duty.

2)

To prevent any accident due to an automatic restart at restoration of power after an inverter stop made by a 
power failure

3)

To rest the inverter for an extended period of time

 

The control power supply for inverter is always running and consumes a little power. When stopping the 
inverter for an extended period of time, powering off the inverter will save power slightly.

4)

To separate the inverter from the power supply to ensure safe maintenance and inspection work

 

Since the MC on the inverter input side is used for the above purposes, they correspond to the standard duties. 
Therefore, when making an emergency stop during running, select a JEM1038 class AC3 MC for the inverter 
input side currents.

.

In principle, do not provide a magnetic contactor between the inverter and motor and switch it from off to on during 
operation. If it is switched on during inverter operation, a large inrush current may flow, stopping the inverter due to 
overcurrent shut-off. When an MC is provided for switching to the commercial power supply, for example, switch it 
on/off after the inverter and motor have stopped.

The MC may be switched on/off to start/stop the inverter. However, since repeated inrush currents at power on will shorten the 
life of the converter circuit (switching life is about 100,000 times), frequent starts and stops must be avoided. Turn on/off the 
inverter start controlling terminals (STF, STR) to run/stop the inverter.

z

As shown on the right, always use the start 
signal (turn on/off terminals STF, STR-SD) to 
start/stop the inverter. 

 

(Refer to page 26.)

*1. When the power supply is 400V class, install a step-down transformer.
*2. Connect the power supply terminals R1, S1 to the primary side of the MC to hold an alarm signal when the inverter's 

protective circuit is activated.  At this time, remove jumpers across terminals R-R1 and S-S1. (Refer to page 10 for 
removal of jumpers)

MCCB

OFF

ON

MC

MC

RA

U

V

W

SD

MC

STF(STR)

RA

RA

MC

T

A

B

C

Power
supply

To motor

Inverter

Start/Stop

OFF

Operation

Operation  ready

*2

*1

R

S

T

R1

S1