Mitsubishi Electronics FR-F700-NA ユーザーズマニュアル
189
setting restriction
4
4.17.2 Parameter write selection (Pr. 77)
(1) Write parameters only at a stop (setting "0", initial value)
⋅ Parameters can be written only during a stop in the PU operation mode.
⋅ The parameters marked in the parameter list (page 62)
⋅ The parameters marked in the parameter list (page 62)
can always be written, regardless of the operation
mode and operating status. However, Pr. 72 PWM frequency selection and Pr. 240 Soft-PWM operation selection can be
written during operation in the PU operation mode, but cannot be written in External operation mode.
(3) Write parameters during operation (setting "2")
⋅ Parameters can always be written.
⋅ The following parameters cannot be written during operation if Pr. 77 = "2". Stop operation when changing their
parameter settings.
You can select whether write to various parameters can be performed or not. Use this function to prevent
parameter values from being rewritten by misoperation.
parameter values from being rewritten by misoperation.
Parameter
Number
Name
Initial Value
Setting
Range
Description
77
Parameter write selection
0
0
Write is enabled only during a stop.
1
Parameter write is not enabled.
2
Parameter write is enabled in any operation
mode regardless of operating status.
mode regardless of operating status.
The above parameters can be set when Pr. 160 User group read selection = "0". (Refer to page 190.)
Pr. 77 can be always set independently of the operation mode and operating status.
Pr. 77 can be always set independently of the operation mode and operating status.
(2) Disable parameter write (setting "1")
⋅ Parameter write is not enabled. (Reading is
enabled.)
⋅ Parameter clear and all parameter clear cannot
be performed, either.
⋅ The parameters given on the right can be
written if Pr. 77 = "1".
Parameter
Number
Name
22
Stall prevention operation level
75
Reset selection/disconnected PU detection/PU stop selection
77
Parameter write selection
79
Operation mode selection
160
User group read selection
296
Password lock level
297
Password lock/unlock
Parameter
Number
Name
23
Stall prevention operation level compensation factor at double speed
48
Second stall prevention operation current
49
Second stall prevention operation frequency
60
Energy saving control selection
66
Stall prevention operation reduction starting frequency
71
Applied motor
79
Operation mode selection
80
Motor capacity
90
Motor constant (R1)
100 to 109
(Adjustable 5 points V/F parameter)
135
Electronic bypass sequence selection
136
MC switchover interlock time
137
Start waiting time
138
Bypass selection at a fault
139
Automatic switchover frequency from inverter to bypass operation
178 to 196
(I/O terminal function selection)
329
Digital input unit selection (Parameter for the plug-in option FR-A7AX)
414
PLC function operation selection
415
Inverter operation lock mode setting
570
Multiple rating setting
♦ Parameters referred to ♦
Pr. 79 Operation mode selection
Refer to page 195