HP (Hewlett-Packard) TC3100 ユーザーズマニュアル

8.  Hold the DIMM at 90 degrees to the system board and press the DIMM firmly and evenly into the slot 

until the retaining latches close. See 3-15.  

It is important to hold the DIMM firmly with both hands and use even pressure so as not to bend or 
break the DIMM connector during installation. If the latches do not close, the DIMM is not inserted 
correctly. 

 

9.  Close the side panel.  

10.  Reconnect the power cord and all external cables.  

11.  Power up the server and return it to normal operation.  

 

If the DIMMs are not seated properly you may get a blank screen.  

You may need to remove a DIMM module to downsize your memory configuration or to replace a defective 
DIMM.  

Follow the steps in the preceding section, but instead of installing a DIMM, remove the DIMM. 

If you power up the HP Server when there are no DIMMs installed, the screen displays an 
error message or appears blank and sounds beep codes. 

The HP Server tc3100 ships with at least one processor installed. Both primary and secondary processor 
sockets are located on the system board (primary processor socket – CPU 1. The voltage regulator modules 
(VRMs) are embedded in the system board. See Figure 3-16. 

Use an anti static service kit (3M

TM

 8501/8502/8503 or equivalent). This kit includes a 

static dissipating work surface, a chassis clip lead, and a wrist strap.