Outback Power Systems 359 ユーザーズマニュアル
16
Problem
Possible
Cause
Solution
Burners will not light using the
ignition system
ignition system
LP gas cylinder is empty
Replace with full cylinder
Faulty regulator
Have regulator checked or replace
Obstructions
in
burners
Clean
burners
Obstructions in gas jets or gas hose
Clean jets and gas hose
Electrode wire is loose or disconnected on
electrode or ignition unit
Reconnect
wire
Electrode or wire is damaged
Change electrode and wire
Faulty integral ignitor
Change ignitor
Burner will not light with a match
LP gas cylinder is empty
Replace with full cylinder
Faulty regulator
Have regulator checked or replace
Obstructions
in
burners
Clean
burners
Obstructions in gas jets or gas hose
Clean jets and gas hose
Low flame or flashback (fire in burner
tube— a hissing or roaring noise may
be heard)
tube— a hissing or roaring noise may
be heard)
LP gas cylinder too small
Use larger cylinder
Obstructions
in
burners
Clean
burners
Obstructions in gas jets or gas hose
Clean jets and gas hose
Windy conditions
Use BBQ in a more sheltered position
Gas valve knob difficult to turn
Integral ignition system jammed
Replace gas valve
Gas valve jammed
Replace gas valve
For reference and correspondence, record your serial number
here.(See sticker on side of barbecue body.)
here.(See sticker on side of barbecue body.)
Serial No.
__________________
This number may be required when ordering spare parts or
accessories. A part reference number may also be required
where applicable.
accessories. A part reference number may also be required
where applicable.
K. Troubleshooting
Published September 2006’