Jenn-Air 750-0165 ユーザーズマニュアル
18
LIGHTING INSTRUCTIONS
BEFORE LIGHTING…
Inspect the gas supply piping prior to turning the
gas “ON”. If there is evidence of cuts, wear, or
abrasion, it must be replaced prior to use.
Inspect the gas supply piping prior to turning the
gas “ON”. If there is evidence of cuts, wear, or
abrasion, it must be replaced prior to use.
WARNING
Do not use the grill if gas odor is present. Contact
customer service at 1-800-554-5799.
customer service at 1-800-554-5799.
Leak check the piping and regulator connections
with a soap and water solution before operating the
grill (see instructions on page 14).
Only the pressure regulator supplied with the unit
should be used. Never substitute regulators. If a
replacement is necessary, contact customer service
for proper replacement 1-800-554-5799.
TO LIGHT THE GRILL BURNER
1. Make sure all knobs are in the “OFF” position,
and turn on the gas supply.
2. The igniter is built into the valve. To ignite each
burner simply press and turn the control knobs
to the “HI” setting, you will hear the valve click
as it sends a spark to the pilot flame.
to the “HI” setting, you will hear the valve click
as it sends a spark to the pilot flame.
3. If the burner does not light, wait 5 minutes for
any excess gas to dissipate and then retry.
WARNING
While lighting, keep your face and body as far from
the grill as possible.
the grill as possible.
FLAME CHARACTERISTICS
Check for proper burner flame characteristics. Each
burner is adjusted prior to shipment. However,
variations in the local gas supply may make minor
adjustments necessary.
Burner flames should be blue and stable with no
yellow tips, excessive noise, or lifting. If any of
these conditions exist, contact customer service.
Yellow flames indicate insufficient air. Noisy flames
or flames that lift away from the burner indicate too
much air. (See the “GAS FLOW CHECK” section on
page 14).
TO LIGHT THE ROTISSERIE BURNER
1. Open the lid and press the knob for about 5
Check for proper burner flame characteristics. Each
burner is adjusted prior to shipment. However,
variations in the local gas supply may make minor
adjustments necessary.
Burner flames should be blue and stable with no
yellow tips, excessive noise, or lifting. If any of
these conditions exist, contact customer service.
Yellow flames indicate insufficient air. Noisy flames
or flames that lift away from the burner indicate too
much air. (See the “GAS FLOW CHECK” section on
page 14).
TO LIGHT THE ROTISSERIE BURNER
1. Open the lid and press the knob for about 5
seconds without turning it. This will allow time
for the gas to flow into the rear burner.
for the gas to flow into the rear burner.
2. Press the knob for 5 seconds, and then turn the
knob to the “HI” setting.
3. Press the igniter button to light the rotisserie
burner.
4. If the burner does not light, turn the control
knob to the “OFF” position.
5. If the igniter does not function, follow the
instruction for match lighting on Page 20.
Keep a spray bottle of soapy water near the gas
supply valve, and check the connections before
each use.