KitchenAid KBNU487VSS ユーザーズマニュアル

ページ / 76
16
Make Gas Connection
Gas Connection to a 20 lb LP Gas Fuel Tank
If converting to local LP or Natural gas, follow the instructions in 
the “Gas Conversions” section.
IMPORTANT: A 20 lb LP gas fuel tank must be purchased 
separately.
IMPORTANT: The gas pressure regulator/hose assembly 
supplied with the grill must be used. Replacement gas pressure 
regulator/hose assembly specific to your model, is available from 
your outdoor grill dealer.
To Install the 20 lb LP Gas Fuel Tank:
1. Open cabinet doors.
2. Pull out the tank tray.
3. Place the 20 lb LP gas fuel tank bottom collar into the 
mounting hole in the tank tray.
4. Tighten the locking screw against the bottom collar of the 
20 lb LP gas fuel tank to secure.
5. Screw the gas pressure regulator/hose assembly to the 20 lb 
LP gas fuel tank as shown. (To disconnect, turn off the gas 
supply to the 20 lb LP gas fuel tank, then unscrew the gas 
pressure regulator/hose assembly from the 20 lb LP gas fuel 
tank as shown.)
6. Turn on the gas supply. Wait a few minutes for gas to move 
through the gas line.
7. Test all connections by brushing on an approved 
noncorrosive leak-detection solution. Bubbles will show a 
leak. Correct any leak found.
8. Slide tank tray back into the cabinet.
9. The batteries are not factory installed. The 1.5-volt “D” size 
alkaline batteries are located in the accessory box on the grill 
grate. Install the batteries at this time following the 
instructions in the “Replacing the Batteries” section. 
10. Go to “Plug in Grill” in this section.
Tank tray
WARNING
Explosion Hazard
Use a new CSA International approved “outdoor” 
gas supply line.
Securely tighten all gas connections.
If connected to LP, have a qualified person make sure 
gas pressure does not exceed 11” (28 cm) water 
column. 
Examples of a qualified person include: 
licensed heating personnel, 
authorized gas company personnel, and
authorized service personnel.
Failure to do so can result in death, explosion, or fire.
A. Locking screw
B. Mounting hole
C. Bottom collar
A. 20 lb LP gas fuel tank
B. Gas pressure regulator/hose assembly
A
B
C
A
B
connect
disconnect