Sharp 0NY42M184304B(1) ユーザーズマニュアル

6

E

•  Since the monitor is heavy, consult your dealer before

installing, removing or moving the monitor.

•  When installing, removing or moving the monitor, ensure

that this is carried out by at least 2 people.

•  A mounting bracket compliant with VESA specifications

is required. Do not use any screw holes other than VESA

holes for installation.

•  When moving the monitor, be sure to hold it with the

handles both on the rear and the unit bottom. Do not hold

the LCD panel. This may cause product damage, failure, or

injury.

•  Install the monitor with the surface perpendicular to a level

surface. If necessary, the monitor may be tilted up to 20

degrees upward or downward.

•  Mounting the monitor on the wall requires special expertise

and the work must be performed by an authorized SHARP 

dealer. You should never attempt to perform any of this 

work yourself. Our company will bear no responsibility 

for accidents or injuries caused by improper mounting or 

mishandling.

•  This monitor should be used at an ambient temperature

between 32°F (0°C) and 104°F (40°C). Provide

enough space around the monitor to prevent heat from 

accumulating inside.

7-7/8 [20]

Unit: inch [cm]

2 [5]

2

[5]

2

[5]

Unit: inch [cm]

2 [5]

2

[5]

2

[5]

7-7/8 [20]

*

*

*  This monitor can be installed close to a wall. However, 

as the monitor emits heat during operation, please be 

aware that this heat may discolor or alter the wall.

•  If it is difficult to provide sufficient space for any reason

such as the installation of the monitor inside a housing, or 

if the ambient temperature may be outside of the range 

of 32°F (0°C) to 104°F (40°C), install a fan or take other

measures to keep the ambient temperature within the 

required range.

•  Temperature condition may change when using the display

together with the optional equipments recommended by 

SHARP. In such cases, please check the temperature 

condition specified by the optional equipments.

•  PN-E471 cannot be used in vertical orientation.

•  Adhere to the following when installing the monitor in its

vertical orientation. Failing to adhere to the following may 

cause malfunctions. (for PN-E421 only)

- Install the monitor such that the power LED is located on

the downside.

- Set the MONITOR on the SETUP menu to PORTRAIT.

(See Operation guide.)

•  Do not block any ventilation openings. If the temperature

inside the monitor rises, this could lead to a malfunction.

•  After mounting, please carefully ensure the monitor is

secure, and not able to come loose from the wall or mount.

•  Do not place the monitor on a device which generates heat.

•  Use the supplied vertical sticker when you install the

monitor in vertical orientation. (for PN-E421 only)

Operation panel

Logo

 Do not remove the factory-affixed sticker but affix the logo

sticker over it. Be careful not to cover the remote control

sensor or buttons.

•  Be sure to use a wall-mount bracket designed or

designated for mounting the monitor.

•  This monitor is designed to be installed on a concrete wall

or pillar. Reinforced work might be necessary for some 

materials such as plaster / thin plastic board / wood before 

starting installation. 

This monitor and bracket must be installed on a wall which 

can endure at least 4 times or more the weight of the 

monitor. Install by the most suitable method for the material 

and the structure.

•  When attaching an optional part, follow the steps described

in the manual for the optional part.

•  For use only with UL Listed Wall Mount Brackets with

minimum weight/load: PN-E471: 102 kg. (224.9 lbs.),  

PN-E421: 88 kg. (194.0 lbs.).