Aussie 6804T80SS1 ユーザーズマニュアル

21

5. Push the Igniter Button in until the Burner is lit. Listen for the spark ignition, and look to make sure the Burner is lit. 

If no spark, see Troubleshooting Section on page 31.

6. From the “Off” position, light all other Burners from left to right, making sure each Burner is lit before lighting 

the next. Your grill has a Crossover Ignition System that allows the Burners to light successively off one another. 
Confirm each Burner is lit before lighting another Burner. 

7. If the Burner fails to light, repeat Step 5. If it still does not light, try the next Burner from left to right.

If a Burner goes out during operation, turn all Control Knobs to the “Off” position and close the LP Gas Cylinder valve to 
dissipate any accumulated gas. Open Hood and wait five minutes before attempting to relight the grill.

If any or all Burners fail to light after three to four attempts following Steps 4-7, turn all Control Knobs to the “Off” posi-
tion and close the LP Gas Cylinder valve to dissipate any accumulated gas. Wait five minutes; then repeat the lighting 
procedures.

 

If the Burners still fail to light, refer to the Troubleshooting Section on page 31. The Burner can also be lit 

manually, see 
Manual Lighting of the Grill on page 21.