Aussie Kanga ユーザーズマニュアル

· Wash the porcelain coated Cooking Grids (41) with a

mixture of hot water and baking soda.  

· Empty the foil pan and grease tray after each cooking

session so excessive grease does not accumulate.
Failure to remove grease may result in grease

· Open Lid or Hood (depending on the model) before

lighting the grill to prevent an explosion from gas

build- up.  
· The Lid (KangaTM series only) must never cover the 

cooking surface while the LP gas grill is in use or hot.

· Always inspect the gas hose and regulator assembly 

before each use.  If the hose is cut, damaged, or
shows signs of excessive abrasion or wear, do not

use  the LP gas grill.  Contact the manufacturer, as the

hose and  regulator assembly must be replaced with
an assembly specified by the manufacturer prior to
further use of the LP gas grill.

3)  From the “Off” position, push control knob in on the left 

burner and turn counter-clockwise until you feel resistance.
Pause 4 seconds, then continue turning the control knob
until a click is heard and the burner is lit.

4)  Light the remaining burners by turning the control knob 

counter-clockwise. Your grill has a crossover ignition system 
that allows the burners to light successively off one another. 
Confirm each burner is lit before lighting another burner.

5)  If any of the burners do not light, repeat Step 3. The burner 

should light within three or four attempts. If burner still does 
not light, try the next burners from left to right. 

following Steps 3 & 4, turn all knobs to the “off”
position and close the valve on the LP gas cylinder.
Wait five minutes; then repeat all of the above lighting 
procedures.  
Note:If the burners still fail to light, refer to the 
Troubleshooting page. The burner can be lit manually, see 
Manual Lighting of the Grill.

6)  After ignition, preheat the grill by turning the control to 

“High” position for 3-5 minutes. The grill should be

pre-heated before every cooking session. The hood
(Bonza™ series only) should be closed during 
preheating. The lid (Kanga™ series only) must never
cover the cooking surface while the grill is in use or
ishot.

for illustrations)
1) Open Lid or Hood (depending on the model)
2) Important:  Make sure control  knobs are turned

“off” first. Open the LP gas cylinder valve by turning
the valve handle counter-clockwise until it stops.