Briggs & Stratton 5900834 ユーザーズマニュアル

 1.  Park the machine on a flat, level surface.  

Disengage the PTO, stop the engine and engage 
the parking brake.  Rear tires must be inflated to 
18 psi (1,24 bar).

 2.  Adjust the mower deck in the 4” (10,2 cm) position.

 3.  Place 2 X 4 blocks under each corner of the 

mower deck with the 3-1/2” sides being vertical.  
Place a 1/4” (0,64 cm) thick spacer on top of the 
rear 2 X 4” blocks.  See Figure 40.

 4.  Adjust the front eyebolts until the chains are tight 

and the deck is still resting on the 2 X 4’s.  Tighten 
the jam nuts.  See Figure 41.

 5.  Loosen the nuts and allow the rear of the deck to 

rest on the 2 X 4’s and 1/4” spacers.  Slide the 
chains down in the slots until the chains are tight 
and tighten the nuts.  See Figure 41.

 6.  Remove all 2 X 4 blocks and spacers from under 

the mower.

 7.  See Figure 42.  Position the outside mower blades 

so they face front-to-back.

 8.  Measure from the front tip of the blade from the 

cutting edge to the ground.  Measure from the 
rear tip of the blade from the cutting edge to the 
ground.  Repeat this process for the other side of 
the machine.

 

•  The front measurement should be 4” (10,2 cm);

 

•  The back measurement should be 4-1/4” (11,43 

cm).

The deck lift assist springs (A, Figure 43) are factory 
set to provide optimal lifting performance.

Although it is fastened with a multi-position anchor, 
this is NOT AN ADJUSTMENT POINT.

Do NOT attempt to adjust the spring length or lifting 
performance will be compromised.

Regular Maintenance

Not 

for  

Reproduction