Mitsubishi Electronics QD75D2N ユーザーズマニュアル
10 - 14
MELSEC-Q
10 HIGH-LEVEL POSITIONING CONTROL
10.3.6 Repeated start (FOR loop)
In a "repeated start (FOR loop)", the data between the " block start data" in which "4:
FOR loop" is set in " Da.13 Special start instruction" and the "block start data" in
which "6: NEXT start" is set in " Da.13 Special start instruction " is repeatedly
executed for the No. of times set in " Da.14 Parameter". An endless loop will result if
the No. of repetitions is set to "0".
(The No. of repetitions is set in " Da.14 Parameter" of the " block start data" in which
"4: FOR loop" is set in " Da.13 Special start instruction".)
FOR loop" is set in " Da.13 Special start instruction" and the "block start data" in
which "6: NEXT start" is set in " Da.13 Special start instruction " is repeatedly
executed for the No. of times set in " Da.14 Parameter". An endless loop will result if
the No. of repetitions is set to "0".
(The No. of repetitions is set in " Da.14 Parameter" of the " block start data" in which
"4: FOR loop" is set in " Da.13 Special start instruction".)
Section [2] shows a control example where the " block start data" and "positioning
data" are set as shown in section [1].
data" are set as shown in section [1].
[1] Setting examples
(1) Block start data setting example
Axis 1 block
start data
Da.11
Shape
Da.12
Start data No.
Da.13
Special start
instruction
Da.14
Parameter
1st point
1: Continue
1
4: FOR loop
2
2nd point
1: Continue
10
0: Block start
–
3rd point
0: End
50
6: NEXT start
–
The "condition data Nos." have been set in " Da.14 Parameter".
(2) Positioning data setting example
Axis 1 position-
ing data No.
Da.1
Operation pattern
1
01: Continuous positioning control
2
01: Continuous positioning control
3 00:
Positioning
complete
10
11: Continuous path control
11 00:
Positioning
complete
50
01: Continuous positioning control
51 00:
Positioning
complete
[2] Control examples
The following shows the control executed when the " block start data" of the 1st
point of axis 1 is set as shown in section [1] and started.
point of axis 1 is set as shown in section [1] and started.
<1> Execute the axis 1 "positioning data No. 1, 2, 3, 10, 11, 50, and 51".
<2> Return to the axis 1 "1st point block start data". Again execute the axis 1
"positioning data No. 1, 2, 3, 10, 11, 50 and 51", and then stop the control.
(Repeat for the No. of times (2 times) set in Da.14 .)
(Repeat for the No. of times (2 times) set in Da.14 .)