Mitsubishi Electronics E60 ユーザーズマニュアル

II - 18 

 

9113  EIA OUTPUT 

In data output mode, select the ISO or EIA code for 
data output. 
In data input mode, the ISO and EIA codes are 
identified automatically. 

0:  ISO code output 
1:  EIA code output 

9114  FEED CHR. 

Specify the length of the tape feed to be output at 
the start and end of the data during tape output. 

0 to 999 (characters) 

9115  PARITY V 

Specify whether to check the parity of the No. of 
characters in block during data input.  
The No. of characters is factory-set so that the 
check is valid at all times. 

0:  Do not perform 

parity V check 

1:  Perform parity V 

check 

9116  TIME-OUT 

Set the time out time to detect an interruption in 
communication. 
Time out check will not be executed when set to 0 to 
30 seconds. 

0 to 30 (s) 

9117  DR OFF 

Specify whether to check the DR data at the data 
input/output. 

0: DR valid 
1: DR invalid 

9118  DATA ASC II 

0:  Output in ISO/EIA code  (Depends on whether 

#9113, #9213, #9313, #9413, or #9513 EIA 
output parameter is set up) 

1:  Output in ASC II code 

0/1 

9119  INPUT FORM 

Specify the mode for input (collation). 
0:  Standard input (Data from the very first EOB is 

handled as significant information.) 

1:  EOBs following the first EOB of the input data are 

skipped until data other than EOB is input. 

0/1 

9121 

9122 

9123 

9124 

9125 

9126 

9127 

9128 

EIA CODE 

[ 

 

] 

 

# 

 

∗ 

 

= 

 

: 

 $ 
 ! 

When output with EIA code‚ data can be output 
using the alternate code in which the special ISO 
code not included in EIA is specified.  
Specify the codes which do not duplicate the 
existing EIA codes by hexadecimal for respective 
special codes. 

0 to FF (hexadecimal)

 

9201 

∼ 

Set the same settings for device 1. 

 

9301 

∼ 

Set the same settings for device 2. 

 

9401 

∼ 

Set the same settings for device 3. 

 

9501 

∼ 

Set the same settings for device 4.