Mitsubishi Electronics E60 ユーザーズマニュアル
3. PROGRAM
ERROR
I - 61
Error No.
Details
Remedy
P 35
CMD-VALUE OVER
The setting range for the addresses has
been exceeded.
been exceeded.
• Check the program.
P 36
PROGRAM END ERR
"EOR" has been read during tape and
memory operation.
memory operation.
• Enter the M02 and M30 command at the end
of the program.
• Enter the M99 command at the end of the
subprogram.
P 37
PROG. NO. ZERO
A zero has been specified for program
and sequence numbers.
and sequence numbers.
• The program numbers are designated across
a range from 1 to 99999999.
• The sequence numbers are designated
across a range from 1 to 99999.
P 39
NO SPEC ERR
• A non-specified G code was specified.
• The high-speed program server operation
• A non-specified G code was specified.
• The high-speed program server operation
specifications are not provided.
• Check the specifications.
P 40
PREREAD BL. ERR
When tool radius compensation is
executed‚ there is an error in the pre-read
block and so the interference check is
disabled.
executed‚ there is an error in the pre-read
block and so the interference check is
disabled.
• Reconsider the program.
P 60
OVER CMP. LENG.
The commanded movement distance is
excessive. (Over 2
excessive. (Over 2
31
)
• Reconsider the axis address command.
P 62
F-CMD. NOTHING
• No feed rate command has been issued.
• There is no F command in the cylindrical
• No feed rate command has been issued.
• There is no F command in the cylindrical
interpolation or pole coordinate
interpolation immediately after the G95
mode is commanded.
interpolation immediately after the G95
mode is commanded.
• The default movement modal command at
power ON is G01. This causes the machine
to move without a G01 command if a
movement command is issued in the
program, and an alarm results. Use an F
command to specify the feedrate.
to move without a G01 command if a
movement command is issued in the
program, and an alarm results. Use an F
command to specify the feedrate.
• Specify F with a thread lead command.
P 65
NO G05P3 SPEC
• Check the high-speed mode III
specifications.
P 70
ARC ERROR
• There is an error in the arc start and end
• There is an error in the arc start and end
points as well as in the arc center.
• The difference of the involute curve
through the start point and the end point is
large.
large.
• When arc was commanded, one of the
two axes configuring the arc plane was a
scaling valid axis.
scaling valid axis.
• Check the numerical values of the addresses
that specify the start and end points, arc
center as well as the radius in the program.
center as well as the radius in the program.
• Check the "+" and "–" directions of the
address numerical values.