Mitsubishi Electronics E60 ユーザーズマニュアル

I - 77 

 

Error No. 

Details 

Remedy 

•  The parameter setting is not correct. 

•  Check the program. 
•  Check the parameter. 

A movement command for exponential 
function interpolation was issued during 
facing turret mirror image. 

•  Check the program. 

Spindle synchronization was 
commanded to a spindle that is not 
connected serially. 

•  Check the program. 
•  Check the parameter. 

A normal line control command (G40.1, 
G41.1, G42.1) was issued when the 
normal line control specifications were 
not provided. 

•  Check the specifications. 

A coordinate system preset command 
(G92) was issued to a normal line control 
axis during normal line control. 

•  Check the program. 

TAN. AXIS LINE 
•  The normal line control axis was set to a 

linear axis. 

•  The normal line control axis was set to the 

linear type rotary axis II axis. 

•  The normal line control axis has not been 

set. 

•  The normal line control axis was the same 

as the plane selection axis. 

•  Correct the normal line control axis. 

The plane selection command (G17, 
G18, G19) was issued during normal line 
control. 

•  Delete the plane selection command (G17, 

G18, G19) from the program for normal line 
control. 

Combining commands that required 
pre-reading (nose R offset‚ corner 
chamfering/corner rounding‚ geometric I‚ 
geometric IB‚ and fixed cycle for 
compound lathe) resulted in eight or 
more pre-read blocks. 

•  Reduce the number of commands that 

require pre-reading or delete such 
commands.