Mitsubishi Electronics E60 ユーザーズマニュアル

II - 4 

 
<T-TIP OFFSET> (Wear data input)  

8010  ABS. MAX.  

(For L system only) 

Set the max. value when inputting the tool wear 
compensation amount. 
A value exceeding this setting value cannot be set.

0 to 999.999 (mm) 

8011 INC. MAX. 

(For L system only) 

Set the max. value for when inputting the tool wear 
compensation amount in the addition mode. 

0 to 999.999 (mm) 

 

<FIXED C.> (Fixed cycle)  

8012 G73 n 

(For M system only) 

Set the return amount for G73 (step cycle). 

0 to 99999.999 (mm) 

8013  G83 n 

Set the return amount for G83 (deep hole drilling 
cycle). 

0 to 99999.999 (mm) 

8014 CDZ-VALE 

(For L system only) 

Set the screw cut up amount for G76‚ G78 (thread 
cutting cycle). 

0 to 127 (0.1 lead) 

8015 CDZ-ANGLE 

(For L system only) 

Set the screw cut up angle for G76‚ G78 (thread 
cutting cycle). 

0 to 89 (°) 

8016 G71 MINIMUM 

(For L system only) 

Set the minimum cut amount for the final cutting in 
G71‚ G72 (rough cutting cycle). 
If the final cutting amount is smaller than this value‚ 
the final cut will not be performed. 

0 to 999.999 (mm) 

8017 DELTA-D 

 

(For L system only) 

Set the change amount to the command cut amount 
D for G71‚ G72 (rough cutting cycle). 
Each cut amount will be the value obtained by 
adding or subtracting this value from command D‚ 
and thus‚ the amount can be changed each cut. 

0 to 999.999 (mm) 

8018  G84/G74 return  

(For M system only) 

Set up return length m at a G84/G74 pecking tap 
cycle.  
Note:  Set "0" to specify a usual tap cycle. 

0 to 999.999 (mm)