Mitsubishi Electronics AJ65BT-D75P2-S3 ユーザーズマニュアル
8 - 8
MELSEC-A
8 ZERO POINT RETURN CONTROL
8.2.4 Zero point return method (2): Stopper stop method 1)
The following shows an operation outline of the "stopper stop method 1)" zero point
return method.
return method.
Operation chart
1)
The machine starts a machine zero point return.
(The machine starts acceleration specified in "
(The machine starts acceleration specified in "
Pr.53 Zero point return acceleration time selection" in the
direction set in " Pr.46 Zero point return direction", and moves at " Pr.48 Zero point return speed".)
2)
The machine detects near-point dog ON and starts deceleration.
(At this time, torque limit is required. If torque limit is not applied, the servomotor may fail at 4).)
(At this time, torque limit is required. If torque limit is not applied, the servomotor may fail at 4).)
3)
The machine decelerates to " Pr.49 Creep speed" and then moves at the creep speed.
4)
The machine comes into contact with the stopper at the creep speed, and stops.
5)
When " Pr.51 Zero point return dwell time" has elapsed after near-point dog ON, pulse output from the
D75P2 stops and "deviation counter clear output" is output to the drive unit.
6)
After the completion of "deviation counter clear output", the zero point return complete flag (RX(n+2)0,
RX(n+5)0) turns from OFF ON and the zero point return request flag (RX(n+1)F, RX(n+4)F) turns from
ON OFF.
RX(n+5)0) turns from OFF ON and the zero point return request flag (RX(n+1)F, RX(n+4)F) turns from
ON OFF.
Machine zero point return start
(Positioning start signal)
(Positioning start signal)
Deviation counter clear output
Axis operation status
[RWrn+7, RWrn+1.5]
[RWrn+7, RWrn+1.5]
Zero point return request flag
[RX(n+1)F, RX(n+4)F]
[RX(n+1)F, RX(n+4)F]
Zero point return complete flag
[RX(n+2)0, RX(n+5)0]
[RX(n+2)0, RX(n+5)0]
Md.44 Movement amount
after near-point dog ON
after near-point dog ON
Current feed value
[RWrn+0 to 1, RWrn+8 to 9]
[RWrn+0 to 1, RWrn+8 to 9]
Md.30 Machine feed value
0
t
ON
OFF
Valid torque limit range
Torque limit
Dwell time measurement
Time out of dwell time
ON
OFF
OFF
ON
V
ON
1)
2)
3)
4)
5) 6)
Range in which the servomotor rotation
is forcibly stopped by the stopper
is forcibly stopped by the stopper
Near-point dog OFF
Standing by
Inconsistent
Inconsistent
In zero point return
Standing by
Zero point address
Value the machine moved is stored
Pr. 48 Zero point return speed
Pr. 49 Creep speed
Stopper
Fig. 8.3 Stopper stop method 1) machine zero point return