Mitsubishi Electronics C64 ユーザーズマニュアル

176 

 

3021 sori 

Orientation 
rotation 
speed 

Set the spindle orientation rotation speed. 
Set the rotation speed for when the spindle 
rotates at the constant rotation speed. 

0 to 32767 (r/min)

3022 sgear 

Encoder 

gear 

ratio 

Set the gear ratio of the spindle to the encoder. 

0: 1/1 
1: 1/2 
2: 1/4 
3: 1/8 

3023 smini 

Minimum 
rotation 
speed 

Set the minimum rotation speed of the spindle. 
If an S command instructs the rotation speed 
below this setting, the spindle rotates at the 
minimum rotation speed set with this parameter. 

0 to 32767 (r/min)

3024 

(PR) 

sout Spindle 

connection 

Set the type of the spindle to be connected. 

0: No connection with the spindle 
1: Serial connection (bus) 
2 to 5: Analog output 

0 to 5 

3025 enc-on 

Spindle 
encoder 

Set connection information of the spindle 
encoder. 

0: No connection 
1: Spindle connection (Spindle encoder 
connection check function valid.)  
2: Serial connection of encoder 

0 to 2 

3026 cs_ori 

Selection 

of 

winding in 
orientation 
mode 

0:  Perform orientation using the winding 
selected when the orientation command is 
issued. 

1:   Use winding L whenever the orientation 

command is issued. 

0/1 

3027 cs_syn 

Selection 

of 

winding in 
spindle 
synchronou
s mode 

0:  The winding H/L is selected by the actual 

spindle rotation speed (calculated from 
commanded rotation speed) when spindle 
synchronous control starts. (The winding is 
not switched during synchronous control. 
The control is carried out with the winding 
selected at start.) 
If the actual spindle rotation speed is less 
than SP020, the winding L is selected, and if 
more than the value, the winding H is 
selected. 

1:   Use winding H whenever the spindle 

synchronous command is issued. 

0/1 

3028  sprcmm 

L system tap 
cycle spindle 
forward run/ 
reverse run M 
command 

Set the M code of the spindle forward run/reverse 
run command. 

High-order three digits : 

The spindle forward run command's M code 
is set. 

Low-order three digits : 

The spindle reverse run command's M code 
is set. 

0 to 999999