Invacare 3650 ユーザーズマニュアル

SECTION 3—OPERATING INSTRUCTIONS

Operating Shower/Massage Wand

NOTE: For this procedure, refer to FIGURE 3.4.

NOTE: STEPS 1 ‐ 3 are to be performed while holding the shower/massage wand over the tub.

1. Turn shower/massage wand on to desired flow by rotating shower On/Off valve

(Detail “A”).

2. Adjust water temperature using the water temperature valve while watching the flow

water thermometer (Detail “B”).

3. Adjust shower spray by rotating shower wand head (Detail “C”).

NOTE: Refer to following chart for shower head adjustment settings.

4. Turn shower On/Off valve to off position when finished.

FIGURE 3.4 Operating Shower/Massage Wand

Filling Tub

NOTE: For this procedure, refer to FIGURE 3.5 on page 27.

1. Close the drain (Detail “A”).

2. Turn tub fill On/Off valve to on position by rotating valve (Detail “B”).

3. Adjust water temperature using the water temperature valve while watching flow

water thermometer (Detail “C”).

CAUTION

Before starting hydromassage, water level MUST be completely above whirlpool

jets otherwise severe damage to the motor/pump will result.

4. Turn tub fill On/Off valve to off position when water reaches desired level (Detail “B”).

Stream

Shower Spray

Mixture of Spray and Pulse Massage

Pulse Massage

Water Temperature Valve

Flow Water

Thermometer

Shower On/Off Valve

Shower/Massage

Wand

Head

DETAIL “C”

DETAIL “B”

DETAIL “A”