Mitsubishi Electronics MDS-D-SVJ3 ユーザーズマニュアル

4 - 15

There is a limit to the load that can be applied on the motor shaft. Make sure that the load applied on the 

radial direction, when mounted on the machine, is below the tolerable values given below. These loads may 

affect the motor output torque, so consider them when designing the machine.

0°C to +40°C (with no freezing)

90% RH or less (with no dew condensation)

-20°C to +65°C(with no freezing)

90% RH or less (with no dew condensation)

Indoors (no direct sunlight);

no corrosive gas, inflammable gas, oil mist or dust

Operation/storage: 1000m or less above sea level

Transportation: 10000m or less above sea level 

196N

245N

490N

980N

1470N

1960N

Consider on the machine side so that the thrust loads are not applied to the spindle motor.

Radial load

(Note) The load point is at the one-half of the shaft length.