HP (Hewlett-Packard) CHPTOH-0711 ユーザーズマニュアル

Your HP remote control is programmable. Program the 
remote control to operate other home entertainment 
devices such as your audio receiver, DVD player, PVR, 
or set-top box. Manufacturer codes for compatible 
brands are listed at the end of this section. 

You can also program a second device such as an 
external sound system for volume mapping, where 
pressing the Volume buttons or Mute button sends an IR 
remote code to adjust the sound level at the second 
device.

Use these steps to program a device button if your 
brand is listed.

Locate the brand of your device and the 
manufacturer’s codes (see the listings in 
“Manufacturer’s codes” on page 53).

Turn on the TV. Turn on the device you want to 
program. 

Press the Device button on the remote control as 
needed to select the device to program (CBL, 
DVD, AVR, or AUX). Wait until the device 
indicator light on the remote control goes out.

Press and hold down the Device button on the 
remote control for 5 seconds, until the device 
indicator light blinks, and then release the Device 
button. The device light blinks one more time and 
then remains lit, indicating the remote control is in 
programming mode.

Enter the first four-digit code for your manufacturer 
from the table. If the code is accepted, the device 
light blinks twice. If the code is not accepted, the 
device light blinks three times.

n

If the brand of your device is not listed in 
“Manufacturer’s codes” on page 53, try 
programming the device code by using the 
steps in “Programming the device code by 
using auto setup mode” on page 52.

n

Read all the steps completely before 
proceeding. Before performing step 4, 
highlight or write down the codes and 
device you want to program. If your 
manufacturer is not listed in 
“Manufacturer’s codes” on page 53, try 
programming the device code by using the 
steps in “Programming the device code by 
using auto setup mode” on page 52.