HP (Hewlett-Packard) CPTOH-0707 ユーザーズマニュアル

Point the remote control at the device, and press 
the Power button once. The device should turn off. 
If it does not, repeat steps 4 and 5, trying each 
code for your brand until you find one that works. 
If it still does not work, try searching for the code 
by using auto setup mode; see “Programming the 
device code by using auto setup mode” on 
page 52.

Repeat steps 1 through 6 for each device you 
want to control with the remote control.

After programming a primary device, you can 
program a second device for volume mapping; see 
“Programming the second device for volume mapping” 
on page 51.

Volume mapping defines a device in addition to the TV 
as producing sound. The TV sound (from the primary 
device) and audio from the second device adjust 
sound at the same time. Pressing the Volume buttons or 
the Mute button sends an IR remote control code to 
adjust the sound level at the second device.

For each device (CBL, DVD, AVR, or AUX) you 
program to control with the remote control, you can 
program a second device for volume mapping. When 
you reprogram the primary device, you must 
reprogram the volume mapping device.

Locate the brand of your device and the 
manufacturer’s codes (see the listings in 
“Manufacturer’s codes” on page 53).

Turn on the TV and the primary device (CBL, DVD, 
AVR, or AUX) for which you want to program a 
volume mapping device. Turn on the second 
device.

Press the Device button on the remote control as 
needed to select the device (CBL, DVD, AVR, or 
AUX). Wait until the device indicator light on the 
remote control goes out.

Press and hold down the Device button on the 
remote control for 5 seconds, until the device 
indicator light blinks, and then release the Device 
button. The device light blinks one more time and 
then remains lit, indicating the remote control is in 
programming mode.

Press one of the Volume buttons. 

Enter the first four-digit code for your manufacturer 
from the table. If the code is accepted, the device 
light blinks twice. If the code is not accepted, the 
device light blinks three times.

Point the remote control at the secondary device, 
and press the Mute button. The sound should 
mute. If it does not, repeat steps 4 and 5, trying 
each code for your brand until you find one that 
works.

Repeat these steps for each primary device (CBL, DVD, 
AVR, or AUX) you want to program for volume 
mapping.

n

!

n