Viking D3 ユーザーズマニュアル

Viking Installation Guide

D3 Built-In Microwave Hood

111 Front Street

Greenwood, Mississippi 38930 USA

IMPORTANT–Please Read and Follow!

•  Please read all instructions thoroughly before installing the Built-In Microwave Hood. Two people are 

recommended to install this product.

•  If a new electrical outlet is required, its installation should be completed by a qualified electrician before the 

Built-In Microwave Hood is installed. See ELECTRICAL GROUNDING INSTRUCTIONS on page 2.

Open the bottom of the carton, bend the carton flaps 
back and tilt the oven over to rest on plastic foam pad. 
Lift carton off oven and remove all packing materials, 
Wall and Top Cabinet Template, Turntable, and Turntable 
Support. SAVE THE CARTON AS IT MAY MAKE 
INSTALLATION EASIER.

•  Remove the feature sticker from the outside of the 

door, if there is one.

•  DO NOT REMOVE THE WAVEGUIDE COVER, which 

is located on the right side wall of the oven cavity. 
Check to see that there is a Wall TEMPLATE and Top 
CABINET Template. Read enclosures and SAVE the 
Use and Care manual.

Check the oven for any damage, such as misaligned or 
bent door, damaged door seals and sealing surfaces, 
broken or loose door hinges and latches and dents inside 
the cavity or on the door. If there is any damage, do 
not operate the oven and contact your dealer or Viking 
AUTHORIZED SERVICER. 

Unpacking and Examining 

Your Oven

1  Mounting Space

This Built-in Microwave Hood requires a mounting space 
on a wall as shown in Figure 1. It is designed to be used 
under standard 12" wall cabinets.

Backguard

At least 2"

15.5"

30"

12"

30" or more 

from cooking 

surface

66" or more 

from floor

1