Fujitsu AOVG12LLCA ユーザーズマニュアル
En-3
AIR CONDITIONER Wall Mounted Type
OPERATING MANUAL
CAUTION
• To prevent malfunction or damage of the remote controller:
- Place remote controller at where will not be exposed to
direct sunlight or excessive heat.
- Remove batteries if the product is not going to be used for
an extended period.
- Exhausted batteries must be removed immediately, and
be disposed according to the local laws and regulations of
your region.
your region.
• If leaking battery fl uid comes in contact with your skin, eyes,
or mouth, immediately rinse with plenty of clean water, and
consult your physician.
consult your physician.
• Obstacles such as a curtain or wall between the remote
controller and the indoor unit may affect the appropriate
signal transmission.
signal transmission.
• Do not apply strong shocks to the remote controller.
• Do not pour water on the remote controller.
• Do not attempt to recharge dry batteries.
• Do not pour water on the remote controller.
• Do not attempt to recharge dry batteries.
Remote controller holder installation
Slide up
Pull out
3
Insert
Press in
2
Screws
1
You can quickly start the operation with following 3 steps:
1 START/STOP
button
2 MODE
button
Switches operation mode in following order.
AUTO
COOL
DRY
FAN
HEAT
Notes in HEAT mode:
• At the beginning of the operation, the indoor unit operates at very
• At the beginning of the operation, the indoor unit operates at very
low fan speed for about 3–5 minutes for preparation, and then
switches to the selected fan speed.
switches to the selected fan speed.
• Automatic defrosting operation overrides the heating operation when
it is necessary.
3
SET TEMP. (temperature) buttons
Set desired temperature.
Temperature setting range
AUTO
64–88 °F (18–30 °C)
COOL/DRY
64–88 °F (18–30 °C)
HEAT
60–88 °F (16–30 °C)
*:Temperature control is not available in FAN mode.
4 FAN
button
Controls the fan speed.
AUTO
HIGH
MED
LOW
QUIET
• When AUTO is selected, the fan speed is automatically adjusted
according to the operation mode.
5 SET
button
Adjusts the vertical airfl ow direction.
6 SWING
button
Starts or stops automatic swing of the vertical airfl ow direction louver.
• Each time you press the button, the vertical airfl ow direction louver
• Each time you press the button, the vertical airfl ow direction louver
swings as follows:
1
2
3
7
6
5
4 4
COOL or DRY mode
HEAT mode
1
2
3
4
5
6 7
Note:
SWING operation may stop temporarily when the fan in the unit is
rotating at very low speed or stopping.
SWING operation may stop temporarily when the fan in the unit is
rotating at very low speed or stopping.
Remote Controller Overview and Operations
5
6
15
12
11
13
14
2
3
16
4
10
7
1
9
8
7 RESET
button
When you press the RESET button, press it gently by using the tip of
a ballpoint pen or other small object in correct direction as shown in
this fi gure.
a ballpoint pen or other small object in correct direction as shown in
this fi gure.
RESET
8 TIMER CANCEL button
Cancels the set timer.
9
ON TIMER button
Each time you press the button, the time changes as follows:
hours
0.5
1.0
1.5
2.0
...
9.0
9.5
10
11
12
• Set the time while the
indicator on the remote controller display
is blinking.
10 OFF TIMER button
Each time you press the button, the time changes as follows:
hours
0.5
1.0
1.5
2.0
...
9.0
9.5
10
11
12
• Set the time while the
indicator on the remote controller display
is blinking.
:
The setting must be done within about 3 seconds during the indi-
cator stays solid.
cator stays solid.
: The button is controllable only when the air conditioner is on.
(continued)
9332621013_OM.indb 3
9332621013_OM.indb 3
9/21/2012 1:23:45 PM
9/21/2012 1:23:45 PM