JVC GV-LS2 U ユーザーズマニュアル
21
Preparation
Searching and connecting to the
access point
access point
1
Select "WIRELESS NETWORK" in "NETWORK".
If the sub settings are not displayed, click "+" on the
left of "NETWORK".
left of "NETWORK".
2
Click the "SEARCH" button.
3
Select an access point to connect to.
If your preferred access point is not in the list, click
the "SEARCH AGAIN" button.
It may not be found if there is a long distance or
interference.
the "SEARCH AGAIN" button.
It may not be found if there is a long distance or
interference.
Connecting to the access point
wirelessly (Wi-Fi)
wirelessly (Wi-Fi)
Using the WPS function
Connect to the access point equipped with the WPS
function easily.
function easily.
1
Press and hold the power button to power off.
2
Disconnect the LAN cable that connects the
camera to your computer.
camera to your computer.
3
Set the network mode switch to "WLAN".
4
Press and hold the power button to power on.
The record button starts blinking. Wait until it stops
blinking and off.
The record button starts blinking. Wait until it stops
blinking and off.
5
Enable the WPS function of the access point.
(Example) Press the "WPS" button.
For how to enable the WPS function, refer to the
instruction manual of the access point.
(Example) Press the "WPS" button.
For how to enable the WPS function, refer to the
instruction manual of the access point.
6
Press and hold the "WPS" button.
When the "WPS" button stops blinking and stays lit,
the connection is complete.
If no connection can be established within two
minutes, the "WPS" button turns off. Try again, or set
up manually.
When the "WPS" button stops blinking and stays lit,
the connection is complete.
If no connection can be established within two
minutes, the "WPS" button turns off. Try again, or set
up manually.