Infocus W59 ユーザーズマニュアル

Settings menu

Audio

: allows adjustments to the volume. Also allows you to turn on and off

the Internal speakers and assign a particular source to a specific audio

input. If your HDMI source has problems with its audio stream, you can

mute it by selecting HDMI Noise Cancel.
Monitor Out Default:

Determines the source (either Computer 2 or Computer

3) which is output through the Monitor Out connector. Computer 2: Out-

puts Computer 2 unless current source is Computer 3 (in that case output

Computer 3 instead). Computer 3: Outputs Computer 3 unless current

source is Computer 2 (in that case output Computer 2 instead). Off: Outputs

the current source if it is Computer 2 or Computer 3. Otherwise do not out-

put any signal.
Sources

allows you to assign a particular input to a specific source key

when using the remote. Also allows selection of a default Startup Source

and enables or disables Autosource.
Sources>Power-up Source:

this determines which source the projector checks

first for active signal during power-up.
Sources>Autosource:

When Autosource is not checked, the projector defaults

to the source selected in Powerup Source. If no source is found, a blank

screen displays. When Autosource is checked, Powerup Source determines

which source the projector defaults to at power-up. If no signal is present,

the projector checks the sources in order until a source is found or until

power down.

System>Rear:

reverses the image so you can project from behind a trans-

lucent screen.
Ceiling

: turns the image upside down for ceiling-mounted projection.

WARNING:

To prevent eye injury if the projector is ceiling mounted,

wear protective eyewear before opening lamp door. A warning sticker is

included with the user documentation. Place this sticker on the lamp

door if the projector is mounted on the ceiling.
IR Receivers:

turns individual IR receivers off or on to avoid environmen-

tal interference.

Auto Power

: When Auto Power is checked, the projector automatically

goes into the startup state after the projector is powered on. This allows

control of ceiling mounted projectors with a wall power switch.
Display Messages

: displays status messages (such as “Searching”) in the

lower-left corner of the screen.

Audio

Settings
menu

Sources

Powerup

Source

System

IR Receivers