Electrolux 316902458 ユーザーズマニュアル

Charcoal Filters, which are attached with Hood 
Louver, are used for nonvented, recirculated instal-
lation. The filter should be changed every 6 to 12 
months depending on use.

1.  Disconnect power to the microwave oven at the 

circuit breaker panel or by unplugging.

2.  Remove three Houver Louver Screws.

3.  Push the upper tabs and pull the louver away 

from the unit.

4.  Remove the charcoal filters from hood louver and 

replace new charcoal filters by piercing tabs into 
the holes in charcoal filters.

5.  Carefully push the louver back into place and 

replace the screws removed at step 2.

Figure 1

Oven Light Cover

Hood Louver

Upper Tab

Hood Louver
Screws

Figure 2

Charcoal Filters

Inside of Hood Louver

Tabs

Remove the louver per instructions 1-3 above, if 
used.

1.  To replace krypton light bulb, first disconnect 

power to the microwave oven at the circuit 
breaker panel or by unplugging.

2.  Open oven light cover by carefully pulling up on 

the front edge. See figure 1.

3.  Remove light bulb and replace 40 watts krypton 

light bulb. DO NOT USE BULB LARGER THAN 
40 WATTS.

4.  Close the Oven Light Cover by carefully push-

ing into place. Push the louver back into place 
(engaging both the bottom and top tabs) and 
replace three Houver Louver Screws.

1.  To replace krypton light bulb, first disconnect 

power to the microwave oven at the circuit 
breaker panel or by unplugging.

2.  To open Light Cover, remove the screw on the 

light cover. (See Figure 3.)

3.  Replace the 40 watts krypton light bulb with new 

one. DO NOT USE A BULB LARGER THAN 40 
WATTS.

4.  Close the Light Cover and secure with screw 

removed at step 2.

(Front of microwave oven)

(Rear of microwave oven)

Light Bulb

Light Cover

Figure 3

Screw

Light Cover may become very hot. Do not touch 
glass when light is on.

ORM 2.0 Side [TINSEB306WRRZ] [0131   31

ORM 2.0 Side [TINSEB306WRRZ] [0131   31

10/20/10   8:41:33 AM

10/20/10   8:41:33 AM